SOURCE: i have a 1992 chev
Master Cylinder (Brake System) :
Worn or leaking brake master cylinder.
Brake Power Booster :
Damaged booster vacuum line/check valve, or diaphram .
Brake Proportioning Valve :
Improper installation/adjustment or damaged proportioning valve .
plz rate this post
SOURCE: abs pump motor on a 2000 dodge 2500 van will not shut off
sensors are in wheel bearings,you may have a bad bearing
SOURCE: 2001 Chev blazer, brakes have been bled, peddle
You probably have air between the master cylinder and the abs pump. Fill the reservior and have someone pump the brake and bleed the primary lines at the abs pump. Good luck.
SOURCE: ABS seems to kick back on brake peddle at slow speeds
low speed activation of abs[will not set off code ] can also do brake studder without touching brake usually does it under 5 mph the problem is one of the sensors is dirty or has some corrosion on it ===chevy back in 2000 did a partial recall on the tahoe for the same problem the fix was to remove the sensor and clean it if the corrosion was to bad than sensor was replaced === the problem with no code is u dont know which sensor is causing problem u would need to remove both and check them
91 views
Usually answered in minutes!
×