What kind of power steering fluid is needed for a 1993 olds cutlass ciera

I really needs checking against the spark plugs you have chosen? .045" is about right for most.

1989-1996 Oldsmobile Cutlass Ciera 3.1L 3.3L V6 6 pc NGK ...

https://www.sixityauto.com > 6-pcs-ngk-v-power-spark...
This 6 pack NGK V-Power Spark Plug fits your 1996, 1995, 1994, 1993, 1992, ... 1989, Oldsmobile, Cutlass Ciera, 3.3L V6;Gap 0.060";Oe Equivalent Design ...

• 
  

  1987-1995 Oldsmobile Cutlass Ciera 2.8L 3.1L V6 6 pc Champion ...

  https://www.sixityauto.com > 6-pc-champion-copper-sp...
  6 pc Champion Copper Plus Spark Plugs for 1987-1995 Oldsmobile Cutlass Ciera 2.8L ... 1988, Oldsmobile, Cutlass Ciera, 2.8L V6;Plug Type Rs15Lyc; Gap 0.045"

What is the Spark plug gap on 95 olds cutlass Cierra? - Answers

https://www.answers.com > What_is_the_Spark_plug_g...
Aug. 4, 2007 - Standard gap is .060" or 1/16".Ask at auto parts counter when purchasing spark plugs. What is the 1972 olds cutlass 2 barrel spark plug gap ...

There should be a filler hole in the power steering unit itself

If it has become really hard to steer, that could be the problem. You will probably need to replace the power steering pump. However, if it has slowy become harder and harder to turn, (especially if it has/had a whining noise) then there is a good chance it is just low on fluid. Check your resevoir. They are USUALLY found closer to the driver's side, under the hood.

one of the lines could be leaking and may have to be replaced or leak in the rack and pinion. cant tell without looking under the hood

First you will need a pulley remover/installer. Remove the power steering belt, remove bolts holding the pump, remove p/s lines, replace in reverse order,and fill pump. Start car and move steering wheel back and forth slightly, then turn the wheel all the way stop to stop Always watch that there is plenty of fluid in the reservoir. Check with dip stick, should be full to bottom mark;

The PCV filter is located in the air cleaner housing and must be replaced every 50,000 miles (80,000 km).

1. Remove the air cleaner housing lid.
   
2. Slide back the filter retaining clip and remove the old filter.
   
3. Install the new filter, replace the retaining clip and replace the housing lid.
   

you will most probably find that the seals in the power steering unit are faulty, clean the power steering lines etc and check to see where the leak actually is, it should be obvious if you are using that amount of fluid.
If it is just the line have a new one made at a hydraulic hose supply shop as it will most probably be cheaper than buying it original.

if it was empty, you must have a leak in the steering system.

Mercon III

with a 3.1 liter , remove and install directions are remove serpentine belt , remove power steering pump assembly , then remove sensor harness , sensor bolt , remove sensor , so it sounds like behind the power steering pump assembly area if that makes sense . it has to be real close the the cam gear , you should be able to find it .