No, Motor comes out the top. Remove hood (With a friend you trust) remove all water hoses from engine, remove wiring from top of engine to fuse box on fender (Be careful if clips are a bit stuck), Undo Exhaust at Manifold / Pipe joint ( This will be a challenge, WD-40 and heat will help),
undo transmission bolts ( Support Trans ) then remove torque converter bolts through Stainless access port, Undo Motor mounts, Chain with large bolts bolted into accessory brackets lift slowly in case you missed anything like Ground wires (Be careful with these as they can cause weird problems later in life) Go Slow, Find a good buddy that has done this before buy him a few beers Not an 18 pack!
SOURCE: Where is the fuse to
under hood in fise box driver side. if that is all good most likly if blower is not working ,, blower motor or blower moter resister is bad along with the harness.
51 views
Usually answered in minutes!
×