SOURCE: car stereo wiring diagram for 2001 mazda tribute
Car Radio Battery Constant 12v+ Wire: Orange/Light Green
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Light Blue/Red
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Light Blue
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Green/Orange
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Gray/Blue
Left Rear Speaker Negative Wire (-): Brown/Yellow
Right Rear Speaker Positive Wire (+): Black/Violet
Right Rear Speaker Negative Wire (-): Orange/Violet
SOURCE: 2002 Mazda Tribute rear liftgate lock replacement
I'm not sure where' the screws are but basically You need to remove the panel on the rear door, then once the panel (interior trim) has been removed you should see a lock mechanism which will be screwed/bolted in place. Easier and cheaper then buying a brand new lock mechanism (unless you want to buy brand new) is going to a wreckers and finding your car model and get it that way (yes it's used but it'll probably save you tons of money vs the dealership) Best Regards.
SOURCE: removing the factory car stereo of mazda tribute
There are holes that need to be poked at the same time to get it out just look for them
SOURCE: 2001 Mazda Tribute (3.0 L) Heater motor functions on high only
Its the Blower Resistor....If it was the switch, it probably wouldn't work at all....But the Resistor will give you those symptoms, of working on high med or low
SOURCE: 2001 Mazda Tribute No transmission-- it will
The plastic rod ends on the cable assy that goes between the shft lever in the colum and the transmittion are worn. I change the cable for the same reason last week and that fixed the problem.
The cable part number is MZEC01-46-500E the price from the Mazda dealer was US $ 64.98. Is easy to change all you need is aphillips screw driver & pliers
56 views
Usually answered in minutes!
×