Dealer with vin or vehicle and proof of ownership
SOURCE: How to exit Radio Safe mode on my passat
Hi
Wiih most radio units....If you have the proper code and have NOT tried
more than 15 times to enter an incorrect code....you should be ok.
Turn OFF ignition switch and remove the key. Switch OFF interior lights. Switch ON Radio unit and SAFE will appear.
Leave everything alone for a period of ONE HOUR. During this time
NO power (no matter how small) should be drawn from the battery.
This is why the interior lights MUST NOT come ON when the door is
opened. Trunk should also remain closed. In the event of any power been
drawn from the battery in this time...You must start all over again.
Radio should after this time return to standard mode...Usually 4
flashing bars. Then enter your code. Dont forget to lock in the code
and all should be fine
All the best with it
John
SOURCE: how do i reset a safe radio of a vw golf 2007
If you don't have the radio card with the code, then you would have to go to the dealer to reset safe code. I hope this helps!
SOURCE: just I wont a code
Drop in to VW dealer. Show proof of ownership and give them code. They may need VIN# too.
SOURCE: I have a seat ibiza 2007. I jump started the
Does your radio offer a four digit input pass code?
Many stereos require this if they have suffered great voltage power loss or if they have been disconnected.
Sometimes if you don't wait until light goes off before cranking it will cause a flash code...Disconnect battery to reset system..If it comes back on replace glow plugs...Best idea is have a Tech diagnose it if the reset test doesn't solve your problem...Save time and headaches....
4,092 views
Usually answered in minutes!
×