5.3L engine, #8 in the picture, probably just a press fit into rubber grommet. After you get the hose off, hopefully it just pulls out.
If you have the I6 engine, there is no PCV, which is why the throttle body needs to be cleaned so often.
SOURCE: PCV VALVE REPLACEMENT
The pcv valve is usually located on one of the valve covers look for the larger vacuum hose coming from the intake manifold and follow it you should find it that way. changing it is a matter of sometimes using a pair of pliers to remove a small clamp then rotate back and forth the pcv valve while holding the hose and pulling it away and off.
SOURCE: 2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION
it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.
SOURCE: p0014 engine code
THE CAM SHAFT ACTUATOR IS LOCATED IN THE CYLINDER HEAD ON THE FRONT RIGHT HAND SIDE JUST ABOVE THE POWER STEERING PUMP. AFTER YOU REMOVE THE ACTUATOR CHECK TO SEE IF ANY OF THE SCREENS ARE DAMAGED OR MISSING. IF SO REPLACE THE ACTUATOR. ALSO CHECK THE CRANKSHAFT END PLAY. IT SHOULD BE BETWEEN 0.0044" - 0.0153". if excessive crankshaft end play is causing this concern, it will be obviously out of specification by as much as.050" or more when a pry bar is used to move the crankshaft back and forth. IF THIS IS THE CASE AN ENGINE REPLACEMENT IS RECOMMENDED DUE TO THE AMOUNT OF DEBRIS IN THE ENGINE. IF NO EXCESSIVE CRANKSHAFT MOVEMENT NOTICED REPLACE THE CAM ACTUATOR. IT WILL ALSO BE NECESSARY TO DO AN OIL CHANGE.
SOURCE: pcv valve replacement
The PCV valve is not removable from the valve rocker arm cover. The PCV valve and rocker arm cover must be replaced as an assembly.
Please Rate This!2,517 views
Usually answered in minutes!
×