I have a 2000 honda odyssey what years of odyssey and or other models are interchangeable parts

SOURCE: where to put in transmission fluid on my 2000 Honda Odyssey

You have a choice! You can use a small funnel and a narrow tube and try to fill through the dipstick tube hole or you can locate the actual fill plug and remove it to gain access to the fill hole. The plug looks like the top of a large bolt and is located on the top of the transmission aft of where the dipstick tube goes in. You will need a long funnel with a narrow opening or a tube to deliver the fluid into the hole.

SOURCE: P0740 code showing in my 2000 Honda Odyssey

P0740 Torque Converter Clutch Circuit Malfunction
The problem could be the torque converter itself or the sensor circuit for the clutch.
Best to have a Transmission Expert look at it to see if any further damage has occurred.

SOURCE: emergency brake adjustment 2000 Honda Odyssey

on the back side of the wheel, there is a thin metal plate. on this plate, there is a rubber plug in a fairly small hole. remove the plug, and just inside, there should be the teeth of an adjuster start wheel visible. turn the star wheel until the drum is tight on the shoes. then, turn the start wheel back, approximately 10 teeth. test and repeat as necessary.

Marvin

• 85242 Answers
• Posted on May 20, 2009

SOURCE: 2000 Honda Odyssey - P1739

P1739 Automatic Transaxle Concernsthis is from the Honda manual, what does this mean? it means there is an electronic shift solenoid fault in the transmission and it need to have the Honda dealer hook up there dealer only test equip to pin down the exact issue with the trans controls.

SOURCE: 2000 Honda Odyssey Fuel Vapour Canister location

It is located at the top of the gas tank. You are going to have to drop the tank in order to check it, so it is best to do this when there is not a lot of gas in the tank. Hope this helps you out.