Ecu light on vehicle in limp mode
SOURCE: 2002 Chrysler Town and Country limp mode
Hello, I have the same problem with my 2002 neon. I was told it was the solenoid pack. I purchased one on eBay (the garage want around $200) for $88. I also bought on eBay the input and output VSS(vehicle speed sensors) for $25 for both. Autozone has these sensors for $27 each. I am going to replace these parts in a day or so to see if it helps.I dont have a garage and its cold outside here in West Virginia. I have also been told to check the ground straps to make sure they are getting good connections. They are located at the starter. I will let you know how this turns out for me when I do the repairs. I have been reading many forums where others are having the same problems. If you have learned anything from your experience please let me know.
Thank you,Dave
SOURCE: limp mode?
It may have a "loss of prime" code that usually follows a service of the fluid and filter. After you're sure the fluid is full at operating temperature, disconnect the battery for a few minutes and reconnect to see if the code resets. I hope this helps.
SOURCE: Im buying a 1986 bmw
You can get hte codes from this BMW by turning the ignition key to the run position and then press the accelerator pedal to the floor 5 times, it will enter the diagnostic mode, count the flashes just like obd 1. Hope this helps, let me know
SOURCE: does a ecu from a merc sprinter or ml fit a grand
From 1992-2002 cherokee shares the same ecu.
Feel safe fitting it.
Rate this, please.
SOURCE: LIMP MODE
to many reset of limp mode set hard no reset in star code system. needs flashed to clear codes and for new transmission. Transmission control module may have oil wicking to it making it send fault codes remove cloth tape and clean with spray cleaner. check turbo hoses, replace TURBO RESONATOR with after market TURBO RESONATOR . Turbo air leak trip limp mode's.
42 views
Usually answered in minutes!
×