Question about Cars & Trucks

1 Answer

I replaced the shifter ,the shows but It doesn't engage in tow mode.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 272 Answers

Posted on Dec 28, 2018

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause my TAHOE TOW/HAUL mode to engage on its own?


You need to have a diagnostic scan tool hooked up ,glitch in one of the control modules or a wire in the circuit shorting to ground ! probably something simple but hard to find ! With a factory scan tool they can check the input signal to the BCM ,PCM .
Tow/Haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the powertrain control module (PCM) or transmission control module (TCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again, or cycling the ignition switch disables tow/haul mode and returns the transmission to a normal shift pattern.

Sep 23, 2015 | Cars & Trucks

1 Answer

Electrical issue


Does the vehicle start an run ? If it does ,the brain as you call it is working fine . The check engine light has nothing to do with the PCM /ECM sensing problems .You probably should take your vehicle to a qualified repair shop .

May 19, 2017 | 2000 Chevrolet Silverado 1500

1 Answer

The tow/haul light comes on sometimes without me engaging the switch on the shifter. I have to sometimes turn the ignition off to get it to go off.


Faulty switch...Replace it,and assure a proper ground...Not too expensive or time consuming..Good Luck

Nov 01, 2013 | Cars & Trucks

1 Answer

2008 ford focus manual trans no gears told shifter housing needs replaced


Same thing just happened to my 2008. I was driving to work and suddenly, no gears available (1-5 or reverse). Had it towed. Mechanic says linkage is connected and working. Has to drop the transmission. Minimum cost is $1,200.00!!!!!

Jul 31, 2012 | 2000 Ford Focus

1 Answer

2001 gmc yukon tow haul engaging disengaing on its on


could be the switch or modual.check wiring for worn through or earthing.

Feb 09, 2018 | GMC Yukon Cars & Trucks

1 Answer

I have a 2000 gmc 1500 Z-71 my tow/haul stays engaged and i am unable to turn it off ...it also come on by itself...


This is only an idea-pull column shifter boot-you will notice a ORANGE wrapped wire which runs from the button on the shifter down toward the steering column. This is the Tow/haul wire. The way this is positioned on the steering column will cause the wire to be pinched when ever the steering wheel is adjusted. This pinching can cause a short or cause the tow/haul not to work at all. NOTE: Inside this orange wire wrap are two very fine fiber wires. Be careful and good luck

Sep 08, 2011 | 2000 GMC Sierra

1 Answer

I have 1997 Jeep Grand Cherokee V8 limited. There are different 4WD modes available. I was wondering which 4WD mode is the most fuel efficient and how do you engage the different 4WD modes?


4 wd part time is the most fuel efficient becuase it only engages when the tires start to spin. to engage the different 4wd modes pull up on the lever next to the shifter and you'll feel it engage into to its respected modes. recommended you engage the 4wd while moving slowly except for 4wd low full time which you need to put the shifter into neutral before you can engage it. remember 4 wd low full time is needed when none of the other modes work.

Jan 16, 2011 | 1997 Jeep Grand Cherokee

1 Answer

02 gmc allison tran. wont go into tow-haul mode


THERE HAVE BEEN ALOT OF PLOBLEMS WITH THE SHIFTER HANDLE/SWITCH. THE BEST WAY TO VERIFY CONCERN IS USE A DIAG. SCANNER & VIEW TRANSMISSION DATA DISPLAY WHILE ENGINE RUNNING. THE SWITCH IN THE SHIFTER IS FAULTY. IF YOU SEE NO INPUT CHANGE WHILE DEPRESSING SWITCH THIS IS YOUR CONCERN.

Nov 08, 2008 | 2002 GMC Sierra 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...