Question about Acura Cars & Trucks

1 Answer

I got a 96 acura 3.5rl it will turn over but won't start the speed omp hand starts jumping and than it starts making a clicking noise could someone help me out wit this problem

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 144 Answers

I sounds like either a dead battery, maybe dirty battery terminal(s) or possible a worn or defective starter motor. If you have AAA or a friend with jumper cables, try jump starting it. USUALLY, if it clicks and dials start jumping around, The battery is either low on charge, damaged internally, has dirty terminal(s) or the car has a bad starter. When you turn the key, the battery may try to supply 9, 10 or 11 volts initially. This is when your gauges start to go up. As soon as a huge power load like your starter tries to kick in, it draws all of the power away from your gauges and they drop. The battery, for whatever reason, doesn't have the power to run the starter motor, the voltage drops, the starter relay drops out disconnecting the starter. The battery voltage tries to recover and your gauges go back up momentarily until the voltage rises enough to start the cycle all over again. Then your gauges drop and on and on. I have seen this with cars where the battery was run down due to headlights being left on, the battery has died of old age, the starter has an internal short or seized bearing or a defective cell connector has broken internally or something as simple as a dirty or corroded battery terminal clamp or cable where it leads into the clamp..The bottom line is that the starter requires an enormous amount of power from the battery for the few seconds that it takes to start the engine. If the battery isn't up to the task for whatever reason, the starter will demand ALL of it's power. A fully charged 12 volt battery's voltage shouldn't drop below 10 volts during cranking. As the battery ages, the terminals get dirty or if the alternator doesn't charge properly, the voltage begins to drop below 10 volts. If you notice the engine cranks slower and get it repaired soon, no harm done. If you drag every last start out of that dying horse, you can damage the coils inside the starter. A horse will run itself to ***** to please it's master. Electric motors are the same way. If all is well, a starter may draw 150 to 200 amps from the battery depending on several different factors like engine size, cylinder compression and number of accessories belted to it. As the battery ages, it's cranking voltage begins to wain. As the cranking voltage drops below 10 volts, that starter will still try to accomplish the same amount of work to start the engine. You don't get something for nothing. So if you have a high compression V8 with a supercharger, air conditioner, alternator and water pump belted to it, normally it may draw 200 amps to start. At 9 volts, it may draw 250 amps to do the job. At 8 1/2 volts, it may go to 275 amps. These windings in the motor in this example were only designed to draw 200 amps. At 275 amps, it's drawing about 40% more power than they're rated at. If you fix this condition in a day or 2, that small abuse can be overlooked. In a busy delivery vehicle driven until it won't start anymore, it is devastating.
I mentioned the starter being bad as a possibility. If it is the original and well used or if it contains a defective bearing or windings, every time you try to start it, even with a new battery, if the motor doesn't turn, it will act like a wrench dropped across the battery terminals and draw the initial battery voltage way down. When you energize any motor, it converts the energy that you put into it into rotational motion and it runs cool. If you lock that motor so it won't turn like with seized bearings or if the windings inside are shorted, all of that energy has to go somewhere. If the motor is locked, the windings will heat excessively drawing way more power than normal. If the windings are shorted, it will draw even more power due to the fact that it won't have any resistance contained in the windings to dissipate all that energy, again, dragging the battery down. I hope your problem is something as simple as dirty terminals. This would only cost a couple of bucks at most or nothing at all if they can be cleaned. Good luck.

Posted on Jan 03, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 98 Answers

SOURCE: 95 acura integra won't start - i have

easy jump start the car to see if its the battery or the altinator. then take off the RED cable to the battery only. if it keeps running its your battery. if it shuts off its the altinator.OR when you jump start the car and you take the cable off and the car shuts down its the altinator. it take 12 volts to lite a bulb it takes 1200 amp to start a car BIG diffence well i hope this helps

Posted on May 09, 2009

Anonymous

  • 1 Answer

SOURCE: 95 Acura Integra starting problem

This happened to me on a 95 Integra GSR and the entire starter did not need to be replaced, just the solenoid pieces. They get old and worn down and the plunger no longer makes a good connection with them, hence the "click". Replace the solenoid panels and sand the plunger and your good as new. You can find instructions for this on the net, just do a search for it.

Posted on Jun 05, 2009

Joseph Hawkins

  • 116 Answers

SOURCE: 2007 chevy cobalt ls won't

Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.

Posted on Jun 06, 2011

caroldon

Donald DCruz

  • 17130 Answers

SOURCE: car won't start makes clicking noise when you

The click noise is the sound of the starter SOLENOID clicking but not contacting to supply voltage to the starter motor.
Now a multimeter test will confirm if the solenoid is contacting and if so then the starter motor is faulty.
It can be due failure of the BRUSH in the motor or the commutator. If so remove the motor and confirm.
Also if the starter pinion is struck the solenoid will click and the motor may not turn.

Posted on Jul 25, 2011

teddquinlan

Tedd Quinlan

  • 30 Answers

SOURCE: 2005 Altima won't start, hear clicking sound coming from fuse box,key stuck in ingintion,won;t turn over,tried to jump start.

the clicking that you hear is coming from the starter relay. sounds like your ignition starter switch or ignition lock cylinder is bad.

Posted on May 30, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 Acura 3.2TL will not turn over


Hit the starter while someone holds the key in "start". Make sure your negative battery cable is good. Can you turn the engine over by hand?

Jun 22, 2014 | 2001 Acura 3.2TL

1 Answer

I have a 1992 vigor and it ran up till the battery went bad and so I bought a new one and now the car wont start. It just makes a click noise and wont even turn over.


A click noise is from a bad solenoid or starter, not the battery. Have someone check out the solenoid and starter. Quick fix.

Nov 04, 2013 | 1992 Acura Vigor

1 Answer

Attempted to jump start my 2001 3.5 rl acura and


10gage cables?
does engine turn by hand? if not,its seized.
the starter can pull 500 amps. (if cold) its called a series wound motor.
and the harder the engine turns, the more amps and HP from this
electric motor. id turn it by hand, if you can turn the engine crank
by hand than try real jumper cable (they cost more) and if they
fail the starter is jammed, or is shorted.
starters can be dead, shorted, open, weak, or jammed.
if the engine spins, take the starter to any autostore, they test it for free.

Sep 30, 2013 | 2001 Acura 3.5RL

1 Answer

I have a 99 Durango that won't start and it also makes a clicking noise jnstead of the bell. it has a new starter, battery and computer. could it be my positive battery cable. it also will not st


Hi Chris, I'm glad to help!

Chris it sounds like you are getting power to the starter when you say it clicks. Here's what you need to do! Take a breaker bar and socket put it on the crankshaft bolt and try to turn the engine over by hand. If you can not move it then take the serpentine belt off and try to turn it over by hand. If you can move it that means something is locked up. Try turning each pulley by hand until you find what is locked up and replace that part. NOTE: If after removing the serpentine belt you still can not move it then your engine is locked up and will need to be replaced or repaired if possible. Hope this helps and have an awesome day Chris.

Dec 12, 2012 | 1999 Dodge Durango

2 Answers

Won't start but can hear starter make a click noise when trying to start with key


will it start with a jump ? if it does replace the battery and have the charging system tested, if it will not start with a jump then most likely you will need to replace the starter.

Dec 07, 2011 | 1999 Chrysler 300M

1 Answer

When i turn the key to start the car,all the elec. cuts off.at the same time it makes as a clicking noise.


Dead battery, charge it or buy a new one or jump it. You have enough juice to play radio and lights, but you dont have the cranking amps to turn the motor over. Thats why it clicks

Feb 01, 2011 | 1987 Acura Legend

1 Answer

I have a '96 Acura TL 2.5, and I need to change out the starter. How do I go about doing this?


my 96 2,5 tl starts when it wants 2 i got a new batt and the alt is good i makes a click sound around the area by the starter and if i get a jump i starts right up how do i go about changing the sterter without breaking that seal on the intake it sits up under

Jun 24, 2009 | 1996 Acura TL Series

1 Answer

New battery & still won't start. Won't even make a noise. DEAD!


sounds like you have a problem with either the ignition switch itself or the solenoid on the starter if you jump positive power to the small wire on your starter and it turns the starter then it would be your ignition switch if it does not turn it replace your starter

May 16, 2009 | 1996 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...