This should help you.
https://www.youtube.com/watch?v=u7jU3DgefZw
SOURCE: 1999 honda accord ex v6
The back brakes on my Honda Accord are disc brakes. After removing the brake cylinder assembly you will see the brake cylinder piston end has a slot in it. The short pin on the back side of the inner brake pad fits into this slot, but also it is used to 'Turn' (clock-wise) the piston back into the cylinder so you fit the assembly back over the new 'thicker' pads. You can not 'press' this piston back into the cylinder.
SOURCE: front and rear motor mounts bad 99 mitsubitshi eclipse gs 2.0L AT
just jack up and remove the driverside motor, just put a piece of lumber between the jack and oilpan, then raise up alittle unbolt front and rear motor mounts should come out easy, then replace and drop engine back into place, its alot easier than one would think, good luck
SOURCE: 2002 Honda Accord. SRS LIGHT CAME ON
Open the door of both sides (driver and passenger) and look for the panel for the fuses. Remove the panel and you will see the fuse box. The information of the fuses is on the panel.
SOURCE: Cost to replace blower motor on Honda Accord?
The part from the dealer is $180.65 ,labor is .5 hours about $50. If you go to a independent shop the cost should be less:)
SOURCE: how to replace rear struts on 2003 honda accord
You will need to rent a spring compressor or borrow one from advance auto parts. The access ports are usually in the back of the car, some have plastic caps over them usually about 6 inches square and some you have to take the inside trim panel off in the car to gain access. Do not attempt to take the struts out without a spring compressor or you will get hurt as the springs are under a lot of pressure so when un bolted without the proper tool they can come apart and you will for sure need a stich or two.
1,396 views
Usually answered in minutes!
×