SOURCE: 2001 Infiniti QX4 low beam bulb replacement instructions
Look directly behind the headlight box if there is a rubber sleave covering the plug take it off. Unplug the wires from the bulb, there may be a saftey clip you will have to pry up to get it off.after you get the plug off the bulb holder should twist counterclockwise then it will pull right off.When you change the bulb just remember to wipe your body oil off the bulb before attaching it back into the headlight box. Then plug it back in and your in business. The high beam has three wires and the low beam has two wires. The bulb will have to be the right one.
God Bless You Greg
SOURCE: how many catalitic converters are on the 2001 infiniti QX4
There are only to Catalysts monitored by the ECM. There is a wide pipe near the front of the exhaust system that looks like it houses a catalyst, but it doesn't. Look for the rear O2 sensor, that is where the catalyst is. If the bolts that hold it on are not badly rusted, and depending on your mechanical aptitude you could replace them, otherwise take it to a shop. Have you checked the warranty coverage with the dealership?
SOURCE: MY 2001 INFINITI QX4 KEEPS SAYING SERVICE SOON
First off, make sure that the gas cap is tightened beyond three clicks. If it is and has been then there are many things that could be causing the light to come on. But let me start by assuring you that it is not something that requires immediate attention. The sole purpose of the service engine light is to detect malfunctions of emissions related components. If the gas cap isn't tight, the computer system detects an incorrect amount of pressure inside the tank due to vapor leaking out of the filler neck. If the cap is tightened after a period of time the computer detects the right pressure and the light will go off. However, on QX4's the most common cause of the light is oxygen sensors, or cam and crank position sensors, and finally intake valve timing control sensors or solenoids. O2 sensors measure the amount of oxygen in the exhaust gas. Normally I have seen that in damp and wet conditions these sensors are more likely to intermittenly give false readings. That being said, although the SES light is not an emergency situation, it will need to be addressed at some point, as the Engine control module takes the readings from these various sensors and automatically adjusts things like idle control, and air fuel mixture ratio, and eventually will to some point affect the performance of the vehicle. I have seen folks drive 100K miles with a service engine light on, so if you don't want to spend a 200 or so dollars right away, I would take the car to autozone, have the codes retrieved, and report back to this forum, at that point I would be able to advise you a little further. But more than likely you could continue driving the car without any driveablility issues.
SOURCE: tryen to find location of the crank sensor on 1998 infiniti QX4
looking for crankshaft sensor on 1998 infiniti qx4
SOURCE: PO744 code 2001 infiniti qx4 how do i fix
CODE PO744 AUTOMATIC TRANSMISSION TORQUE CONVERTER CLUTCH SOLENOID VALVE FAULT. POSSIBLE CAUSE FAULTY TCC SOLENOID.CHECK TCC SOLENOID WIRING FOR DAMAGE.OR YOU COULD HAVE FAULTY TCM OR ECM. IF THE TCC SOLENOID IS FAULTY YOUR ENGINE WILL STALL OUT AT A RED LIGHT OR STOP SIGN.YOUR ENGINE WILL STALL OUT AT EVERY STOP THAT WOULD BE SIGN FAULTY TCC SOLENOID.IF ENGINE DONT STALL OUT THE TCC SOLENOID COULD COULD BE STUCK OPEN, IF YOUR TORQUE CONVERTER FAULTY IT WILL CAUSE PREMATURE LOCKUP STALLING OUT THE ENGINE.
99 views
Usually answered in minutes!
×