Think simple, 1 fuse, 2 child lock out switch, 3 is window jammed in track, 4 check the wires
Could be the relay contacts for the motor or if the window has a drive cable the drive cable could be dried out.
First ck to see if you have power at the motor when a a witch is activated. If there is power then it's a matter of adjusting the mechanism...and make a smooth running glass. 2nd if you have no power at the motor then you need to ck downstream towards the power source to find the cause.
could be fuse or switch.
SOURCE: removing rear door panel
Remove the door window regulator handle and then remove clip using a piece of cloth (Manual type only)
Remove the rear door inside handle housing.
Remove the mounting screws (3EA) from the trim fasteners and the door trim panel to pry off. Disconnect the connector.
Insert a trim panel remover between the trim fasteners and the door trim panel to pry off. Disconnect the connector.
Remove the door pull handle mounting bracket and door inside handle.
SOURCE: rear window won't roll up/down
likely window regulator inside ..the driven part to your drive motor ...need to open up and replace inside ...good luck
SOURCE: 1994 jeep grand cherokee power window problem
try replacing the master switch it maybe malfunctioning due to wear.or may have shorted out by getting wet or something.since it is the primary control for all windows and power door locks.
SOURCE: power windows
This means you need to head to the junk yard and replace the unit that controlls all the windows from the drivers seat. Very simple fix. Good luck
SOURCE: Passenger side front and back window not working.
I have the same problem i have found out the way to fix it though. You have to pull the door panel off and at the top of the door you will hopefully see a white guide pully if you see that you can feed the cable back through it. if you dont see that pully you have to get a new one. Mine broke so i am trying to find one now.
53 views
Usually answered in minutes!
×