How do you change brake light on a 99 chevy tahoe

Watch the video at the link below. Third Brake Light Bulb Change Chevrolet Tahoe 2000 2006 2005 Chevrolet...

Open the hatch, fastens from inside

images for 2002 Tahoe abs relay location

Chevy ABS and Brake Dash Light fix - YouTube

? 24:15
https://www.youtube.com/watch?v=Jo76ylqgUR8
Dec 22, 2012 - Uploaded by Skizzot7
This is how to fix intermittent ABS and Brake dash lights on all Chevrolet ... That board is rather robust and is installed external to the vehicle in a location that sits .... I took the module out of a2002 Sierra and it is engineered with no T10 .... ABS Sensor and Harness 2000-06 Chevy Suburban Tahoe GMC ...

How I fixed a Chevy with an Abs and Brake light on - YouTube

images for 2002 tahoe wiring

Look where the wiring harness comes through the rear passenger compartment. Theres usually a junction that splits off then goes to the back tail lights, I beleive there is also a ground wire somewhere in the same vicinity. Sounds like theres a short in the harness at that junction or the ground is maybe loose or rusted and not making contact.

I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!

Try having the dealer flush and bleed your system. It is very hard to bleed ABS systems yourself and have safe brakes that still work afterward. Bleeding non-ABS brakes yourself is easy not the same for ABS brakes. Valving, sensors and what-not require a tech and the correct equipment in my opinion. You do it wrong and you could ruin your ABS system. Do that and see if they firm up. I replaced my brake shoes/pads at the same time all new everything in back, drums/springs everything and new rotors up front. then I had the chevy dealer flush, refill and bleed system. Stiffer pedal and brakes work better. Keep in mind the brakes on 99 Tahoes are inaedequate, require new rotors often, heat up and fade/glaze pads regularly. I replace my pads long before they wear down because they glaze up and start fading early. I'll rough em up once maybe, next time, new ones. Every two brake jobs, new rotors for me. Just how it is. They will stiffen a bit and work better but they will never be awesome brakes. Just how it is on 99 and earlier Tahoes. Hope it helps. Very important to bleed correctly though. I'll bleed my 83 Toyota 4x4 myself but not the Tahoe.

still have air in the brakes

98 Z71 Chevy rear end will work on this. You may need to get a kit to install disc

check for short in tailights. or this happend on my tahoe but it was the factory trailer wires that had a short under the rear of the truck.

the brake light switch. under dash behind brake peddle arm.