Mitsubishi eclipse 2002 how do i tighten the steering

Mitsubishi Eclipse 2002 Steering wheel - YouTube

? 1:50
www.youtube.com/watch?v=CkfZFAd26z4
Feb 28, 2012 - Uploaded by JonaBGlezz
La instalacion de mi nuevo STEERING WHEEL HUB QUICK RELEASE, En una ma?ana fria y de mucha hueva

The mechanic who did the work may have gotten coolant on the drive belts or not sufficiently adjusted the belt tension . I'd replace the belt especially if the sides of the belt are shiny.

first you must remove all of the old intake eqipment but dont remove the metal part with the wires coming out of it that is your map sensere it will have a mesh that is improtant to keep as well. remove the old airfilter box. the instale should be easy just make shure to reinstall the metal peace with the wires uesing the provided adapter. tighten all your hose clamps and install your filter and that should be it.

if you are just shoping around I own the 3.0 L spider and had much better resalts with a short ram intak.

you will need to tighten the adjusting cable, here is a website that tells the removal, it should help Tim:

http://www.ehow.com/how_4590676_replace-throttle-body-mitsubishi-eclipse.html

Your gear timing may not be correct for the timing belt.

Removal
Remove steering wheel and combination switch. See STEERING WHEEL & AIR BAG and
COMBINATION SWITCH . Disconnect ignition switch electrical connector. Using a chisel and screwdriver,
back out bolts at steering lock bracket. Insert key into steering lock cylinder, and turn to ACC position. Using a
small Phillips screwdriver, push cylinder lock pin inward. On all models, remove ignition switch, steering lock
and bracket.
Installation
To install, reverse removal procedure. Use NEW steering lock bracket and bolts. Temporarily install ignition
switch and steering lock cylinder onto steering column. Ensure ignition switch functions normally, then tighten
steering lock cylinder bolts. Tighten lock bolts until heads twist off. To complete installation, reverse removal
procedure.
If you need anymore info let me know.

its mounted front part under dash by steering column around knee area

http://www.onlinefreeebooks.net/automotive-machinery-power-equipment-ebooks/mitsubishi/2000-2002-mitsubishi-eclipse-eclipse-spyder-service-manual-pdf.html

this will solve your question and then some

its by your intake manifold on the bottom of the engine block. there is a heat shield covering it which will need to be removed to get to it

cat costa mitsubishi eclipse 2002