I haven't been able to find the replacement part for the pcv valve. Just the hose.
Standard Motor Products part # V415 is the valve I see listed if you're careful you can reuse the hose. I hope this helps. Take care.
Testimonial: "This says its for a Ford. I have a Chevy. Will this still work?"
SOURCE: 2006 Chev Cobalt oil filter replacement
i have a 2006 chevy cobalt LT..and i just replaced my oil filter today!!! after several hours of looking i finally looked on the front side of the transmission block.to the left just below the air intake system is a hard heat resistant plastic black bolt topper.it is 1 1/4" in size..i bought a 1 1/2" size and a 36mm size socket torque wrench..both didnt work..1 1/2 was way too big, the 36mm was just slightly too big..took them back, replaced for the 1 1/4" inch socket and voila!!! is was rather difficult..you will need an extender and some good torquing to do to pop it..but once you do it will pop fine..oh, and you will need a 1/2" drive socket wrench.but the 1 1/4"inch socket..pop it onto a 1/2" drive socket wrench with the extender and you are good to go!!
SOURCE: pcv valve replacement
The PCV valve is not removable from the valve rocker arm cover. The PCV valve and rocker arm cover must be replaced as an assembly.
SOURCE: PCV VALVE REPLACEMENT
The pcv valve is usually located on one of the valve covers look for the larger vacuum hose coming from the intake manifold and follow it you should find it that way. changing it is a matter of sometimes using a pair of pliers to remove a small clamp then rotate back and forth the pcv valve while holding the hose and pulling it away and off.
SOURCE: my 2006 chevy cobalt 2.2 liter sputters
Fault with the IAC valve.there maybe a trouble code associated with it also./ Go to your nearby autozone or auto parts retailer and ask them to put a scanner to the car....make note of the codes if any are found. the IAC valve i usually locate don the throttle body and can be removed for inspection and sometimes cleaning using a good throttle body cleaner spray and a pipe cleaner brush.
SOURCE: Fan switch does not work in the 1, 2, 3, position 2006 Cobalt
You have a problem with the blower motor resistor. This is a very commen problem on all gm cars and light trucks. The part is not to pricey. You can find the resistor under the glove box buy the blower motor. Two bolts and out it comes.
769 views
Usually answered in minutes!
×