Okay but when I bought the 08 audi q7 quattro
it was like the engine was new like from the dealership new the only thing the radio was not working so I had to go to the trunk fuss was blown out so I changed it closed then I went n my house 20 Minnie's later I go to my suv trip to stared then it just say ESP FAULT SEE OWNER MANUEL???
Yes there is you will find it in the main fuse box located on the drivers side under bonnet just below windscreen for R/H drive vehicles .
for L/H drive may be on opposite side
this link may be useful https://mahorkka.com/images/
SOURCE: windshield wipers in front wont work but rear wipers work
Hi! U need to check the switch and the wiring circuit that controls the motor.
SOURCE: Changing the wiper motor on a 1997 Audi A3
Here you will find the replacement of the wiper motor for Audi A4. Maybe similar for Audi A3! First you must diagnose your problem. In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works. Heed of the windscreen !!! Refit all in reverse order. Success!
SOURCE: wiper not working on my audi A3
you left something disconnected the wiper motor is connected to a transmission and transmission is connected to wiper pivots and pivots move wiper arms seems like you missed something
SOURCE: audi a3 54 plate .new wiper motor fitted by dealer
The problem is in the wiper switch assembly itself.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
SOURCE: remove bateries from audi q7 remote and required disassembly.??
- Buy a CR2032 3V battery
- Pry open the battery cover on the remote using a flat head screw
driver or a table knife. The pivot point is the chain ring holder opposite to the key.
- Replace battery
1,059 views
Usually answered in minutes!
×