SOURCE: carnt find diagnostic plug on car
see the headlight regulator on the driver's side. You'll then see a plastic Bolt. Turn 90 degree counter clockwise with a 2 Pence coin and open the Flap. Voilla the OBDII Plug is there.
SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"
usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.
SOURCE: how to remove starter motor on peugeot 307 1.6hdi
The hard bit is getting to the starter to unscrew the bolts and getting enough room to remove it once loose. YOu will need to take off a number things from the top of the engine.
The starter is located at the front middle of the engine under the diesel filter.
You will be able get to two of the starter bolts from under the bonnet and the other from below.
You will need to loosen or remove the wiring from around the top of the engine to allow you to remove the starter once loose. (remember where all the plastic connectors reattach).
You should only attempt to do this if you are fairly confident with spanners and have a decent set. You will need 10mm, 11mm, 12mm, 14mm spanners and sockets. 8mm socket, 8mm Allen bolt (straight allen key), small torque.
It is not difficult to do the job just to get to the starter and get enough room to remove and replace. Takes about 4 careful hours start to finish for a none mechanic with car on jacks.
You should always disconnect the battery while removing any electrical/mechanical part from car for safety reasons.
This will help. Thanks please keep updated. please please do rate the solution positively
.thank you for using fixya
SOURCE: peugeot 307 1.6
peugeot and citreon cars do bite high generaly, it is hydaulic there is no adjustment. but it also depends on how high it is ?? does it slip if you slightly rest your foot on whilst driving?? they do have a problem with the bearings going through the cover as it is the same bearing as a HDI . but you woud notice this as a different problem. ie noise or vibration on pedal. call me for more info .. paul @ the clutch centre..01527 64440 07790438337
SOURCE: how to reset peugeot 307 electro-power steering?
but did you buy it new? if yes you need to go to a peugeot dealer to have programmed, if not and broken you have to replace it if you want to be sure disconect the cable from power steering motor and you will find all full of oil ciao
143 views
Usually answered in minutes!
Hi Trish Mesterhazy, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? What year?
Hi it's a Peugeot 307 cc 2005
I am also Looking for the fuse that is for the mirror adjustment switch?
×