SOURCE: 1993 ford ranger supercab
the fuse box is inside the pickup under the drivers side dash, there is a flasher which is the round one in the fuse box, it controls turn signals and emergency flashers also in the same fuse box, there is a 15 amp fuse which controls just the turn signals it sits vertical instead of horizontal.
SOURCE: Replace heater core in 1988 Ford Ranger
allow the system to cool down
take radiator cap loose to release pressure
once pressure is released tighten cap
loosen clamps on the heater hoses in the engine compartment on the pass. side of firewall.
plug or cap off the heater core tubes to prevent spillage when you pull it into the truck
place a trash bag on floorboard in case spillage occurs
remove the five screws holding the heatre core access cover, three on top and two on bottom
carefully pull heater core back and down and remove it from the dash
install is reverse
Hope this helps
SOURCE: ford ranger fuel shutoff switch
i bet its the ecm relay if it starts cutting out then dies then it is the ecm relay i had one that did the same thing if its your fuel relay unplug it clean the terminals and plug it back in if it still does it buy a new one and replace if you bypass it you take a chance of burning the truck too the ground and if ya dont really care about that then find your positive wire in the plug with the key on and hook it too the one that runs your fuel pump so its hard wired
SOURCE: How do you remove the gear shift lever on a 93 ford ranger?
many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck
140 views
Usually answered in minutes!
×