First thought- defective cylinder. Now when you say blown out do you mean came apart and the cups and cylinders came out? If that is so then I would say faulty installation. The cylinder rod may not have been installed correctly. Or the shoe hold down springs came apart.
Testimonial: "Thanks. Gives me a good idea of what to expect when I get into it today. What a mess...got a puddle of brake fluid on the garage floor. Greeaatt! :o)"
SOURCE: 1998 Cavalier No Spark in cylinders 1 & 4
ignition mod. grounds,pcm or timing belt could all be it but, I would have to look at timing first.
SOURCE: cylinder 2 misfire on a 1998 chevy blazer
check your plug wires for tears and dont overlap them
SOURCE: 200 Chevy Tahoe 5.7L
Do you have any engines codes like P 0300. Sounds like ignition coils ,check input wires to coils if okay replace both coils.I have seen this few times
SOURCE: 2004 chevy silverado 1500 4 wheel drive wont work..
try selecting from nutreul or less then 3km
SOURCE: 1999 chevy silverado service 4 wheel drive light
I had a similar problem with
the Service 4 Wheel Drive light which came on intermittently then became more
consistent in the message center display. It would go into 4 wheel drive if the
message center did not display the Service 4 Wheel Drive message in the message
center, but not when the message was displayed. I found the transfer case
switch module in the dash was defective, and it has been working with no other
problems for three years.
61 views
Usually answered in minutes!
×