My database showed lower right rear of engine block. If starter motor is there you may have to drop it, to get at the sensor. I can't see anything from here.
Should be down by the balancer
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: Where is the crankshaft position sensor located?
the crankshaft position senor on the 2.2L is located on the rear right side of the engine block
SOURCE: crankshaft position sensor location
1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition
coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor
A
magnetic crankshaft sensor (Hall Effect switch) is used which is
remotely mounted on the opposite side of the engine from the DIS/IC
module. The sensor protrudes in to the engine block, within about 0.050
in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
Testimonial: "Awesome. Thanks."
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
SOURCE: Where is the crankshaft position
Hello Aldozer.
It is mounted below the power steering pump and behind the AC compressor(if equipped).
Both will need to be removed to access it.
Here is a pic of the engine after they are removed.
I hope this helps you towards a good repair.
Thank you for using FixYa.
KL
915 views
Usually answered in minutes!
×