3.8 l sxt
Get the knowledge about the fault and how to fix the problem in service and repair manual with pictures and diagram on your own and you will get the manual from the given link https://toolsnyou.com
SOURCE: Replacing side mirror on 2008 Dodge Grand Caravan
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: compressing the rear disc brake caliper on 2008 grand caravan
The rear calipers on these models require a special tool that compresses and turns the piston in at the same time -- most parts stores carry this tool.
It is called a caliper piston press -- and it installs where the pads would go and acts like a c-clamp,when turning handle it will turn the caliper piston backinto the caliper as it compresses it.
Anytime the brake rotor or brake pads are being replaced, the rear caliper piston must be seated (bottomed) to compensate for the new brake rotor or lining. Because the Parking Brake self-adjuster mechanism is attached to the piston, a special seating method is required. The only acceptable method is by rotating the piston back into the bore using Retractor,MILLER Special Tool 8807, . Any other seating method will damage the self-adjuster mechanism.
Good luck and hope this helps.
SOURCE: 2007 grand caravan sxt access to bulbs in interior lights
I just took mine out and it looks like it has burned out, and even the plastic holder has black on it like it was on fire!! Just take a thin small flat head screwdriver and sort of pry the plastic lens cover off. Be careful, as you could break it. Just pull down on it and it comes loose. You turn the light bulb housing counter clock-wise and it releases. Pull the bulb out.
SOURCE: how to remove front rotors on 2008 dodge grand
You will need a big C clamp and a 21 mm socket.
Remove the wheel.
Use the C clamp to compress the front brake piston:
Just put the screw side of the c clamp on the outside brake pad and the frame part of the c clamp on the back of the caliper and turn the c clamp in until it won't compress further. You don't have to over-do it. Don't force it and don't do this with the back brakes...they require a tool that rotates the piston as it compresses... Hint: rent it from auto zone for free.
Once the piston is compressed, use the 21mm socket to remove the two caliper bolts and then tie up the caliper so it doesn't hang down in the way and stress the brake lines.
Then you need to bang on the rotor with a mallet until you free it and it will come off.
You may need to hammer it pretty hard.
That's it.
Assemble in reverse.
117 views
Usually answered in minutes!
×