SOURCE: whow to remove center trim panel on dash board for
on the dash top the center section is removed by holding tightly from the sides and slide it toward the windshield until it unlatches. if you mean the one around the radio , it is most of the dash face and has 2 screws at top of instrument cluster and 2 more hiding at the bottom under the the a/c controls way back just above the very front of center counsel.
SOURCE: Removal of door panel/trim
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: How do I replace the convertible pillar post
no,pull the weatherstrip back nearer the windshield and there are screws hidden under there>
SOURCE: remove 2004 Dodge Grand Caravan D-pillar panel
To remove the panel completely. You must remove all screws & the seatbealt bolts for the 2nd & 3rd seats
SOURCE: How to remove the car stereo from 2007 Chevy Colorado
This is not hard but tricky because the trim plate around the radio has clips that hold the trim plate very tight.Use a plastic type flat tool or flat screw driver wraped with tape or a shop rag to avoid damage to the plastic trim and pry the trim panel around the radio loose. remove all elec connectors.Then remove the screws that hold the radio in place and remove all elec connectors.
REMOVAL
(1) Remove quarter trim panel.
(2) Remove the bolts attaching the latch to the cab
side panel.
(3) Remove the nuts attaching the frame/hinge to
the B-pillar.
(4) Remove the glass from the cab.
(5) If necessary, remove the latch from the glass.
INSTALLATION
(1) If removed, install the latch to the glass.
(2) Center the window glass at the opening, insert
the hinge studs in the B-pillar holes, and install the
nuts.
(3) Attach the latch to the rear side panel with the
bolts. Tighten the bolts with the latch in the lock
position and pushing rearward on the latch.
(4) Test the vent window for water leaks.
(5) Install quarter trim panel.
INSTALLATION
(1) If removed, install the latch to the glass.
(2) Center the window glass at the opening, insert
the hinge studs in the B-pillar holes, and install the
nuts.
(3) Attach the latch to the rear side panel with the
bolts. Tighten the bolts with the latch in the lock
position and pushing rearward on the latch.
(4) Test the vent window for water leaks.
(5) Install quarter trim panel.
126 views
Usually answered in minutes!
×