Front fenders need to be removed

Fender -Front Removal

1. Remove the radiator grille opening panel reinforcement (8A284).

1. If equipped, remove the front wheel opening moulding.
   1. Remove the pin-type retainer.
   1. Remove the screws.
   1. Remove the wheel opening moulding.

1. Remove the front fender splash shield (16103).
   1. Remove the screws.
   1. Remove the pin-type retainers.
   1. Remove the front fender splash shield.

1. Remove the cowl grille.

1. On RH front fender, remove the antenna mast.

1. On RH front fender, remove the antenna base.
   1. Remove the radio antenna base cap (18A927) by gently inserting a thin straight-edged screwdriver underneath the cap and carefully following inside the perimeter until both snaps are free.
   1. Remove the screws.
   1. Lift the antenna base.
   1. Disconnect the radio antenna lead-in cable (18812) and remove the antenna base.

1. Remove the fender stuffer.

1. Remove the stone guard.
   1. Remove the pin-type retainers.
   1. Remove the stone guard.

1. Remove the front fender.
   • Remove the bolts.

The timing chain should not routinely need changing, but perhaps the tensioner does.
Try first to eliminate any other causes, like the bearings in the fan, drive belt idlers, or alternator. A useful tool is a long screwdriver which you can apply to the various areas while placing your ear to the top of it while the motor idles.
Be very careful to keep clear of moving parts like fan blades.

you have blown your red line check gaskets from throttlebody gasket directly to the front of the intake. while running motor spray some brake cleaner around the areas one leak and you hear the automatic change in sound of motor. replace and torge to specs.

I dont think there is a factory amp in your car i might be wrong but, if it is aftermarket check under seats, or behind glove box beside computer... according to the wiring schematic i have it said different ...notice were is states location of amp and trigger.
2000 Toyota Celica Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Blue/Yellow
Car Radio Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: N/A
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: Black
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Violet
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Blue
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White

The easiest way to change them is to remove the 3 bolts that hold the headlight in place, 1 is directly on top of the headlight, 1 can be seen thru the upper radiator support(of course be sure to remove the plastic engine compartment covers if they are installed), and the 3rd is hidden underneath the front bumper cover, to remove the front bumper cover, move aside the inner wheel well panel nearest the sidemarker lights, pull the bumper cover off slighty fron a plastic snap lock that lines up the bumper with the fender, you should see the bolt as soon as you pull the bumper cover. Each bolt is a 10mm patern so I recommend a small ratchet with extension, once you remove the bolts, the headlights come right off. You might have a rubber cover over where the headlight bulbs are located, simlpy unscrew it, or pull it off whatever your vehicle has, I believe the bulb type is H7, its a standard low-beam bulb, keep in mind the passengerside headlamp is attached to the windshield washer refill reservoir which snaps in and out of place. Install is reverse procedure, I hope this helps, and if you need, go to Newcelica.org for ANYTHING Celica related.

try reseting the alarm,maybe all thats needed.....

Never as it does not have a timing belt but instead has a timing chain that requires no maintenance and should last the life of the engine.

nothing try back flushing heater core, they clog up due to litle water preasure,you might want to flush cooling system if you already havent, hope this hleps.

Get another opinion from someone you trust

Only 87 -89 convertible fenders will work on the convertibles.