Can I have diagram and images
SOURCE: I need a 1998 Dodge Grand Caravan serpentine belt diagram.
The belt routing diagram is shown on a decal located on thehorizontal metal support above the radiator and under the hood support rod (passenger's side near the coolant overflow tank).
PT Stanley
SOURCE: compressing the rear disc brake caliper on 2008 grand caravan
The rear calipers on these models require a special tool that compresses and turns the piston in at the same time -- most parts stores carry this tool.
It is called a caliper piston press -- and it installs where the pads would go and acts like a c-clamp,when turning handle it will turn the caliper piston backinto the caliper as it compresses it.
Anytime the brake rotor or brake pads are being replaced, the rear caliper piston must be seated (bottomed) to compensate for the new brake rotor or lining. Because the Parking Brake self-adjuster mechanism is attached to the piston, a special seating method is required. The only acceptable method is by rotating the piston back into the bore using Retractor,MILLER Special Tool 8807, . Any other seating method will damage the self-adjuster mechanism.
Good luck and hope this helps.
SOURCE: Where is the fuse box
Fusebox is next to the battery, and you can get a free manual here: http://www.dodge.com/en/owners/manuals/
Thanks for using FixYa.
SOURCE: how to remove front rotors on 2008 dodge grand
You will need a big C clamp and a 21 mm socket.
Remove the wheel.
Use the C clamp to compress the front brake piston:
Just put the screw side of the c clamp on the outside brake pad and the frame part of the c clamp on the back of the caliper and turn the c clamp in until it won't compress further. You don't have to over-do it. Don't force it and don't do this with the back brakes...they require a tool that rotates the piston as it compresses... Hint: rent it from auto zone for free.
Once the piston is compressed, use the 21mm socket to remove the two caliper bolts and then tie up the caliper so it doesn't hang down in the way and stress the brake lines.
Then you need to bang on the rotor with a mallet until you free it and it will come off.
You may need to hammer it pretty hard.
That's it.
Assemble in reverse.
SOURCE: remove rear evaporator core 2008 dodge grand caravan
it is inside the right rear corner of the van with line connections under the van you will need to remove the plastic cover inside the rear corner
143 views
Usually answered in minutes!
×