Question about Dodge Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
so after completely tearing the seat apart I found 2 wires going up to the seat belt mechanism from under the seat, these wires got caught in the seat mechanism underneath and were shredded. There must be a small solenoid inside the seat belt mechanism because I could hear it click after I repaired the wires(this circuit is live even with the ignition off) Im not sure how it all works but this solved my problem.
Posted on Jun 12, 2008
There are plastic gears connecting the track to the seat assembly. Whne one of these strip the seat will only work or move to one side. Infiniti does not sell a simple fix. You are looking at buying an entire seat assembly complete with the module for all the electronics. It will be at a cost of around $950 - $1000. Once that is in, Infiniti must program the seat to the brain of the car, only then can you reset your memory settings.
Posted on Oct 02, 2009
I just solved the problem for a stuck rear center seat belt in my 2002 Jetta.
Flip the base seat cushion forward against the front seat backs. Trace down along the belt to its tether point on the floor. The belt is sewn around a steel loop. The loop is anchored to a black steel hook. A thin silvery retainer plate is spring tensioned on top of the loop to prevent it from sliding off of the hook when the seat back is folded.
Therefore, you need to press the silvery retainer plate away from the hook (push up) to allow the loop to be slid from the hook. The belt was tight with the seat back in the upright position, so it was necessary to fold the seat back forward to create slack in the belt. Now push the belt loop towards the trunk and slide it off of the end of the hook (only possible with the retainer plate pushed up out of the way).
Now with total release of tension on the system via the bottom end of the seat belt being untethered and with the seat back returned to the upright position, normal extension and retraction of the belt will be reestablished. Next, simply extend the seat belt and slide the loop back into place over the floor hook. It snaps past the silvery retainer plate without all the effort required to hold the plate up during removal of the loop during disassembly.
Check again, the seat belt should be extending and retracting properly. Now just put the seat cushion back into regular position and you will be able to safely buckle up three people across the back seat.
It took about as long to do this repair as it has taken to post this answer to the problem. Note, the seat belt safety mechanism only allows normal extension and retraction of the belt when the seat back is upright.
Posted on Dec 18, 2009
The problem lies in the drivers side seat, the heating element for the back of the seat or the seat heating element has an open or shorted circuit. the part from ford will run you about $150.00 dollars.
Posted on Nov 26, 2012
Tips for a great answer:
Nov 20, 2013 | 2009 Hummer H2
Jul 03, 2013 | Cars & Trucks
Sep 15, 2011 | 1990 Honda Accord
Aug 07, 2010 | Toyota Camry Cars & Trucks
Sep 14, 2009 | 2000 Dodge Ram 1500 Truck
Aug 12, 2009 | 1995 Volvo 960
Aug 04, 2009 | 1988 Mercedes-Benz S-Class
May 30, 2009 | 1996 Dodge Ram 1500 Club Cab
Nov 16, 2008 | 1999 Volvo S80
May 21, 2008 | 1999 Dodge Ram 2500 4WD
40 people viewed this question
Usually answered in minutes!