How do you change a speed sensor in a 2006 chevy equinox LT. 4.2. -L

SOURCE: 2006 Chevy Equinox

Hiya...the factory-installed keyless remote control are installed in most Equinoxes IF SO equipped with this option that year.
However, it's difficult to get "true factory-installed" keyless feature in your Equinox ....but new 2008-2009 Equinoxes built this year now comes with standard keyless remote and yes, new option is remote STARTER feature (that option is identified by a black wire found inside the rear-right quarter window with thin metal line surrounding that interior window to receive signal from remote starter fob)

At least you can find after-market keyless remote control at your local retail store.

Marvin

• 85242 Answers
• Posted on Mar 26, 2009

SOURCE: 2006 chevy equinox keyless remote programming

from the service manual:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Please go to the nearest GM dealer for assistance

Greg Bernett

• 2993 Answers
• Posted on Sep 03, 2009

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
2. Remove the left front wheel and wheelhouse liner.

1. Disconnect the knock sensor (KS) connector.
2. Detach the knock sensor (KS) from the engine block.

1. Attach the knock sensor (KS) to the engine block.
   • Tighten the bolt to 18 ft lbs (25 Nm).
2. Connect the knock sensor (KS) connector.
3. Install the left front wheelhouse liner and wheel.
4. Fully lower the vehicle.

SOURCE: cost to change thermostat on chevy equinox lt 2005

thermostats are cheap usually under $20 and most of the time very easy to install

SOURCE: how do you change an oxygen sensor on 2006 chevy aveo

There is a special socket for O2 sensors which allow the wires to stick out and not get twisted up. It's not expensive and available at most auto parts stores. Disconnect the sensor from the wiring harness, with the plug and then use the socket to remove and replace the new sensor. Re-connect electrical plug.

Please rate this answer. Thank you.