My Cruise Control Wont work, is there a special way to turn on the cruise, because the sign for cruise comes up but it doesnt cruise

If cruise control main light comes on but you cannot set a speed (no set), you could have a bad brake pedal switch.
(If the cruise control light comes on, chances are that it is NOT a fuse issue).
Some vehicles have two switches (one for brake lights and one for cruise control cancel) and others have a multifunctional, single switch.
The function to cancel cruise control is very sensitive so it only takes a small movement of the pedal to cancel cruise control.
You can try lifting on the brake pedal while trying to set the cruise, but this does not alway work. Replace switches are pretty cheap (less than $30) and pretty easy and quick to replace.

The fact that the light comes on is a good indication that the electronics are working, the most common problem is a vacumn leak. This can be a damaged or cracked vacumn line, a bad check valve, or the dump switch on the brake pedal

Fuses are a great place to start, if not fuses the actual cruise control switch may be to fault. Rear heater do you get heat out the front and if so is there a fuse for a rear fan maybe a blower.. Let me know

Once you have turned your cruise control on accelerate to desired speed press SET button on right hand side of steering wheel before lifting foot from accelerator, then remove foot from accelerator. pushing RESUME button will deactivate cruise control without turning it off. Then when clear of traffic push resume again to activate cruise control. It will automatically resume to previous set speed.

sounds like the switch has a fault

Try pulling up the brake pedal with your foot,Sometimes your brake doesnt come back all the way,and the brake switch keeps the cruise from working.Also,check the fuse.If those answers dont help,It could be the swith itself is bad.Those can be bought at a parts store.

You have a short somewhere dude

could be a main relay acting up or your cruise control module is in need of replacing also check vaccum lines for signs of deteriation or cracking

check your on and off button at the steering wheel.
use a multi-meter set in the ohm postion and see if there is conectivity as you push each button. you will have to take the button off the steering wheel but it will take
just a few minites. while your at it you can check the right side also.
the set-resume-coast.