I would start off by locating your 3 or 4 major ground points such as batt ground to frame, batt ground to block, block to firewall ground strap. Make sure they are clean and tight! Also check your battery terminal connections as well. That will eliminate any weird ground/electric issues and possibly save you some problems down the road too!
I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years
SOURCE: how to clear engine codes 1999 dodge ram 2500
This is the most up-to-date check engine code reference chart for all of Dodge including
Diesel.
2000 and newer Durango have a built-in system that can display check
engine light (CEL) codes without the use of a scanner. 1999 and earlier
Durangos must be read with a OBD-ll scanner. Your local auto parts
store can get the codes for you either way and will usually do this for
free.
hope this help let me know : - )
2000 and newer directions:
Turn the key to ON (not start), OFF, ON, OFF, ON and leave it there.
If you look in the odometer window the codes will flash any code(s) with
a small delay between each result. Each code should be in a P####
format, and will say PDONE when completed - turn your key to OFF and
remove. Use the OBD code list to determine what problem the computer
detected.
To reset your engine codes:
Remove the negative terminal of your battery (10mm wrench).
Turn your ignition key to START and hold it there for about 15 seconds.
Turn your ignition key to OFF and remove it.
Connect the negative terminal of your battery.
Start but do not hit the throttle. Idle for about 10/15 seconds then turn off.
Restart the truck and drive as usual. It will take at least 12 starts
and 48 miles to fully retune the computer. Hard Codes leave a shaddow
for 40 full cold starts.
SOURCE: 2001 dodge 2500 v10 has low idle
On my 06 v10 there is a idle adjustment screw at the linkage on the throttle body.
clean air filter
clean sensor in the air intake ram
try some 93 octane
SOURCE: running roug at low idle, smooths out at 2500 rpms
change plug and wire if its been a while most cars have 90000 miles platinum plugs in them.but the wires wear before plugs.so change plugs and wires.+clean fuel injectors .change fuel filter and air filter.if car still run rough your idling to low.have idling check .
SOURCE: 2001 dodge ram 2500 v10 oil pressure drops to 0 then back up
you need to put an oil pressure gauge on it and see what happens.what you will find is that the sender unit is no good.
SOURCE: 1999 Dodge Ram 2500 Diesel 4x4
check engine light on code says speed senceor this sounds right sents speedo not working so i changed both the sensores but still check engine light on and speedo and cruise not working
741 views
Usually answered in minutes!
×