Crank no spark on a 1977 Dodge Dakota pickup is there a crankshaft sensor on that pickup

Dodge Dakota Crank No Start Fix - YouTube

? 8:10
https://www.youtube.com/watch?v=a-rfAd0YLg0
Jun 29, 2014 - Uploaded by AJ Pierce
In this video, I will show you how I fixed my 1992 Dodge Dakotanot starting. ... Engine cranks but won't start - Duration: 18:30. jimthecarguy ...

Inspect Fuses if Engine Cranks But Does Not Start : Dodge ...

repairpal.com > Problems > Dodge > Dakota

Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Dakota ... cap and rotor, wires, plugs, coil, fuel pump assy, coil pickup sensor, crank position sensor and have new ECM on the way, Cranks but won't fire. ... 1990 Dodge Dakota.

Dakota won't Start - Discussion on Topix

www.topix.com > Dodge Dakota

Jan 22, 2009 - have a 1993 dodge dakota sport that wont start. when you turn the key on there is no power to the fuel pump and does not fire. any ideas ... I just bought a1990 Dodge Dakota Sport 4x4 5-Speed, there is only one problem, it only .... I went to move it the other day, it would turn over, but had no spark or gas.

Dodge Dakota Questions - PROBLEM STARTING - CarGurus

www.cargurus.com > Questions > Dodge > Dakota

CarGurus

These videos should be helpful
1998 dakota crank position sensor repair August 2011
https://www.youtube.com/watch?v=m_uAnQFjTI4

test and replace coil and make sure power is geting to the coil

poss cam sensor inside distributor, crank sensor on top of transmission on passenger side or the ignition module inside of computer went bad!

The crank sensor is on the front of the engine it triggers off the front crank pulley. The pickup you changed is the Camshaft position sensor and will cause hard starting but not a complete no start. A picture of the Crankshaft position sensor is below.

The fuel pump pressure shoud be 55-61 psi . Check for spark by removing a ignition wire at a spark plug and put a spark plug in wire and hold to engine ground and crank engine , if no spark then remove coil wire at cap and repeat.If still no spark then coil , module,,crank sensor or pickup may be the problem.
Check fuel pump pressure first and if available check for codes for possible crank sensor.

It should be on the left front (driver's side). Check the intake manifold, if it's factory each cylinder should be listed.

replace pickup coil in the distributor

There is a sensor that located on the right side of trans. that goes into bellhousing up close to the engine, it runs off the flywheel i think its the crank sensor but i'am not sure, i had a simmler problem with one i was working on, replaced that and it ran.

a bad crank sensor or dist pickup plate can cause this.... check the fuses in the fuse block under the hood for any blown ..... a bad auto shut down relay may cause it .....try putting a test light on the green and orange wire and see if it lights up when you try to crank it