They sell adapters so cutting up oem Harnesses need not be down
the diagram is in the service manual on all cars.
https://www.scosche.com/car-audio/installation/harness
SOURCE: 96 Jeep Cherokee WON'T start
i just had the same exact problems as zeeladys. It was the crank sensor shorting out and causing the short to shut down circuits in the pcm, volt gauge, fuel gauge, no spark. Locate the connector to the crank sensor, it runs beside the distributor, with the key to the on position unplug the connector and see if the gauges come back on. If so, simply replace the crank sensor and ur off and running
SOURCE: 2005 jeep grand cherokee radio
It's in the engine compartment IOD#2. It's a black module with two fuses in it. Take that module off and replace the 20 AMP one.
SOURCE: serpintine belt
This link will take you to a picture of the diagram. If the link doesn't work contact me and I can email you the picture directly.
http://autorepair.about.com/library/illustrations/bl506a-lib.htm
SOURCE: 2003 Jeep Vacuum Diagram
THERE SHOULD BE A EVAP/VACUUM DIAGRAM UNDER THE HOOD ON A WHITE STICKER. SOMETIMES THEY ARE ON THE BOTTOM SIDE OF THE HOOD ITSELF. I HOPE THIS HELPS. PLEASE KEEP ME POSTED THANKS FOR USING FIX-YA AND FOR AN HONEST RATING/COMMENT. GOOD LUCK
SOURCE: 96 Jeep Grand Cherokee diagnostic codes P1762 and
governor pressure sensor in transmission is the likely problem
367 views
Usually answered in minutes!
×