Question about 1995 Isuzu Rodeo
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
123456 IS THE FIRING ORDER... RIGHT BANK (RIGHT AS IN SITTING IN THE DRIVERS SEAT NOT STANDING IN FRONT OF THE CAR)STARTING AT FRONT IS CYLINDER 1 THEN 3 THEN 5 THEN THE LEFT BANK IS CYLINDER 2,4,6, FRONT TO REAR... THE COILS FROM LEFT TO RIGHT (STANDING IN FRONT OF CAR) ARE 1,4,6,3,2,5 HOPE THIS HELPS
Posted on Mar 27, 2009
if the grille screws are accessable remove the grille which should give you access to the underside of the lock, you may need a screwdriver to push the lever aside to release the hood
Hope this helps
Posted on May 23, 2009
SOURCE: Where is the obd port
Here is a photo of the obd connector on a 1993 Isuzu Trooper.
The connector is on the transmission hump about 6 inches from the accelerator pedal. It is inside a black hood. Right next to the white OBD connector is an identical green connector that I have not tested.
The OBD port is a white 3 hole plug. Right next to it in the photo is a green 3 hole plug that I believe is for automatic transmission diagnostics. The plug is different from other plugs under the dash as it will not accept a .25" tab connector.
The picture shows a 20 ohm resistor being used to short pin 1 and 3 of the white plug. The resistor is to prevent a melted wire in case the plug shorted is the wrong plug.
To read the error codes from the engine computer, the mechanic is supposed to short pin 1 and pin 3 of the OBD port plug. Then the mechanic turns on the ignition switch and counts flashes of the "check engine" light to determine the error values being reported.
Posted on Sep 20, 2009
Tips for a great answer:
Dec 20, 2017 | Isuzu Cars & Trucks
Dec 19, 2017 | Isuzu Cars & Trucks
Jun 22, 2012 | Isuzu Rodeo Cars & Trucks
common Chrysler fix - Replace Leak Detection Pump / LDP
Repair damaged EVAP lines or canister
Repair open or short in voltage feed circuit to Purge Solenoid
Repair open in PCM purge command circuit
Replace purge Solenoid
Replace vacuum switch
Repair restriction in Evap line or canister or soleniod
Repair resistance in purge connector
Sep 01, 2011 | 1995 Isuzu Rodeo
Oct 26, 2009 | 1995 Isuzu Rodeo
Oct 18, 2009 | 1995 Isuzu Rodeo
Jul 15, 2009 | 1995 Isuzu Rodeo
37 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: