There is a video here
https://www.google.com/search?q=replace+a+tail+light+in+a+2016+Hyundai+Elantra
..
SOURCE: 2002 hyundai elantra tail light replacement
I have done one on 03 if its the same inside of trunk there are several retainers for the interior liner remove these and pull liner back there are 2 or 3 nuts behind that panel once removed lense will come out it comes out kind of hard but it does come out then you just twist the socket out of lense to get to bulb
SOURCE: No power at socket for right break light for 2003 Hyundai Elantra
As you can see in this wiring diagram, power supplied is series/parallel
SOURCE: 2003 hyundai elantra gls abs/tcs light on
unless you can discover what DTC (Diagnostic Trouble Code) has been recorded/set in the control module, it's anyone's guess.
Testimonial: "thankyou"
SOURCE: 2003 Hyundai Elantra GLS. Check engine light, code PO133
Did you use a aftermarket O2 sensor or a genuine Hyundai one? If it's an aftermarket one it may be bad or not as good as the OEM one. See here for more details and other potential causes: P0133
SOURCE: how to replace 2002 hyundai elantra hub and bearing
With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.
63 views
Usually answered in minutes!
×