2004 Ford Taurus Logo

Related Topics:

Posted on Jul 01, 2019

My 2004 Ford Taurus has three ports one in the front I'm sure is high pressure two in the back passenger side pretty close together look identical in size the colors of the cap is different the hoses to coming out of look the same ones green ones black of those two in the back which one is the low pressure port anybody know because I've been to O'Reilly's and I've been to AutoZone and I've asked a lot of people and I've done tried to put the stuffing I've told I've been told two different things on those parts I've tried the black one and the one in front the one in front is a high-pressure that's why my house wouldn't fit it but that's what they told me at AutoZone where's the port anybody know

  • dropsofmail Jul 01, 2019

    I'm old and broke keep the link but thanks anyway man

  • dropsofmail Jul 01, 2019

    I have been trying the correct port then why is the quick connect hose not snapping in place, I had someone else try also. Pushing down until fingers hurt and it comes right off... I don't get it

×

1 Answer

Rick in LA

Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 3 Answers
  • Posted on Jul 01, 2019
Rick in LA
Contributor
Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Mar 02, 2008
Answers
3
Questions
0
Helped
4435
Points
39

5 Related Answers

Anonymous

  • 15935 Answers
  • Posted on Apr 23, 2009

SOURCE: AC low pressure port 2001 Ford Ranger 3.0L

look for lo and hi on the cap.
please see this layout diagram... and you can trace it down yourself.

b91f44a.jpg
The lines coming on the dryer canister are HI side.
Use the opposite one to charge.

Thanks for using FixYa - aFixYa rating is appreciated for answering your FREE question

Ad

Anonymous

  • 1 Answer
  • Posted on May 19, 2009

SOURCE: where is the a/c low side service port for 1995 Ford Taurus

Locaed on the bulkhead on the passangers side. A plastic shield runs along the top of the bulkhead hald by three plastic clips and screws. remove this and you will see the connector port.

jimmy

  • 409 Answers
  • Posted on Apr 26, 2010

SOURCE: where is low side port for recharging a/c. on my

The port on the accumulator is the low side. The high side port is smaller than the low side. The low side port is the one that gets cold when the compressor is running.

Anonymous

  • 1 Answer
  • Posted on May 06, 2010

SOURCE: R134a recharger nozzle won't fit on low pressure service port.

The low pressure port on the 2003 grand am is actually behind the engine, near the firewall on the passenger side. Good luck getting your hose down there though, I ended up buying an extension hose.

Anonymous

  • 1874 Answers
  • Posted on Jul 13, 2010

SOURCE: Where is the high pressure port for ac on 2006

The high pressure port (service connector) for A/C on 2006 Ford Focus is on the left upper corner side of the radiator.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Where is the low pressure port ?

That port would be located at the rear of the passenger side fender well under the hood. It's kind of against the firewall. Be carefull of moving parts as the front of the engine is right there. Good luck

I’m happy to help further over the phone at https://www.6ya.com/expert/robert_24775b73ca70da93

1helpful
1answer

Where is low pressure port for air conditioner

As your standing in front of the car look back by the firewall just to the right of the passenger side strut tower.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

0helpful
2answers

2004 ford taurus ses 3.0 pretty sure th.e fuel pressure regulator is bad but don't know if it's in tank or on fuel rail. Have to turn key couple times to fully prime pressure and car runs at...

The fuel pressure regulator is on the fuel rail..But it sounds like to me like a stuck idle air control or a vacuum leak..Look carefully at all the vacuum lines and make sure they are not broke or crimped..If it stuck idling high you can tap on the valve and the idle will come down
3helpful
3answers

How do I bleed the brakes on a 2002 Ford Taurus?

You need two people...one in the drivers seat and one working the wrench on each brake caliper....Make sure fluid is full. Start with the back passenger wheel and have them pump brakes up and hold it....Use a wrench and loosen bleeder on caliper. Pedal will go to the floor. Close it and have them pump it up again. Have them hold it again then do this to each wheel two to three times.....Back passenger first, then back drivers, front passengers, then front drivers....Doing this forces the air out of the lines
1helpful
2answers

Im looking for the low pressure port on a 96 ford taurus ?????

Oh, that's an easy one. The low pressure side is made up of larger diameter tubing than the high pressure side (aluminum tubing) that holds the refrigerant.

Also, the low pressure side always gets cold when working properly with the a/c on. The cold low pressure side piping will develop condensation on a hot day.

Sometimes the low pressure port is located on a post that sticks up and has a blue or black cap on it, similar to schrader valve but different.

The quick connector connects to the hose found in an r134a kit that may have a 12 oz. can of r134a for bumping up the amount of freon in your system (sometimes cars leak this gas slowly through o-rings).

Good luck to you on this.
0helpful
1answer
3helpful
1answer

How to replace high/low beam switch on 2004 Ford Focus LX?

Should be fairly easy. Make sure to disconnect the positive battery cable. Remove the cover from around the column behind the steering wheel. Should take a star driver to remove the screws holding the cover together. Once the screws are removed pop the cover apart and you will see the multifunction switch on the column, should have two to three screws holding it to the column remove the screws and it should come out pretty easy replace with new one and put back together.
7helpful
3answers

R134a recharger nozzle won't fit on low pressure service port.

The low pressure port on the 2003 grand am is actually behind the engine, near the firewall on the passenger side. Good luck getting your hose down there though, I ended up buying an extension hose.
2helpful
2answers

Where do you add refrigerant to a 97 sho?

The high pressure port is in front of radiator fill reservoir. The low pressure port is located by the passenger strut tower.
Not finding what you are looking for?

124 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...