Well according to my mitchell manuel you don't have to.here is the procedure.
1. open the hood.
2.Remove the push-pin retainer's that secure the top of the upper facia and grill assembly to the upper tie bar to allow the upper facia and grill assembly to flex forward.
3. remove ther bolt and push-pin retainer that secures the top of the headlight assembly to the upper tie bar.
4. Gently pull the upper facia and grill assembly forward to access the bolt on the inboard side of the headlight assembly
5. Pull the headlamp assembly straight out to disengage the the snap in retainer at the lower outboard back surface of the assembly. Turn the assembly so that the inboard assembly clears the front facia.
6. pull the assembly out and away from the veh.From there you'll be able to access bulbs.
be careful not to touch the bulb with fingers or oil in skin will blow bulb.
Good luck.
That's a good tip, but for a permanent repair, get the updated light sockets from the dealership.
Check out my pix at http://srxturnsignals.shutterfly.com/
The front headlight on my car flickers then turns off. The dealer says its the balancer and wants $900.00 for a replacment. Is this for real? has anyone else had this problem?
671 views
Usually answered in minutes!
×