Replace 2001 silverado 1500 4x4 windshield washer fluid reservoir

If the hatch window washer jet is not working in your 2016 Ford Explorer Sport, there could be a few possible causes. Here are some steps you can take to troubleshoot the issue:

1. Check the fluid level: First, make sure that the windshield washer fluid reservoir is filled with fluid. If it is empty or low, the washer system won't work properly.
2. Inspect the hose: Check the hose that connects the washer fluid reservoir to the hatch window washer jet. It may be clogged or disconnected.
3. Check the washer jet: Inspect the hatch window washer jet for any signs of damage or blockage. You can use a pin or a small piece of wire to clear any blockages.
4. Check the fuse: If the washer pump is not working, check the fuse for the washer system. The fuse may have blown, and you will need to replace it.
5. Check the washer pump: If the fuse is fine, check the washer pump. The pump may have failed, and you will need to replace it.

If none of these steps work, it may be best to take your Ford Explorer Sport to a certified mechanic to diagnose and fix the issue.

Check fuses or washer pump. .replace.

Have you checked to see if you have a cracked reservoir ? Could also be a hose that is cracked or maybe the washer motor came off the reservoir.

images for Ford Freestar Washer fluid bottle

How To Install Replace Windsheild Washer Reservoir Bottle ...

? 13:32
https://www.youtube.com/watch?v=kA38mzgMCkk
Jun 11, 2012 - Uploaded by 1A Auto Parts
How To Install Replace Windsheild Washer Reservoir Bottle FordEscape ... a broken, damaged, split or leaking windshield washer bottle.

How To Install Replace Leaking Windshield Washer Fluid Bottle 2000 06...

Your line runs from the reservoir in the fender well, up through the hose around the strut plate on top, through the bezel to the wipers. If you have no leaks, Replace the washer motor. If you fill it and it leaks, fix the leaks. To access the reservoir. Remove the tire and inner fender well on the passenger side.

The seam on the windshield fluid container is broken and leaking like crazy.

1) don't these cars come with a 5 year 50,000 mile warranty? if so take it to a dealer

2) if not under warranty I would replace the washer fluid lines coming from the washer fluid reservoir. something has become disconnected and fluid is not getting to the nozzles. you may need a repair manual to show you how to get to them.

Hello, I know of no product capable of a long lasting repair. You might be able to seal it on the outside with some sort of epoxy but a better fix would be to replace it with a new reservoir bottle. To remove it you need to unbolt that skinny brace above the battery and remove the battery and unbolt the top bolts of the washer reservoir. CAUTION, if you have the THEFTLOCK radio be sure to disable it before removing the battery cables. Set the parking brake and chock the rear wheels. Loosen the lug nuts on the driver's side wheel just enough to break them loose and jack up the driver's side and place a jack stand on a solid part of the frame, remove the driver's side wheel. Remove the inner wheel liner to give you access to the bottom reservoir bolts and pump, disconnect the electrical connector and unbolt the pump motor and washer reservoir, then slide it down and out, being careful of the small tube that carries the fluid to the wipers. Installation is the reverse, good luck and if you have any other questions don't hesitate to send a comment.

right where the lines connect to reservoir, has little black seals that leak. I recommend removing reservoir, empty it out, then use RTV silicone and place it between seals and reservoir. Let it dry for FULL day. than reinstall.