My ABS light is staying on.

no information generic answer have vehicle scanned ---check brake fluid level / condition --brakes --abs sensors--hubs

yes it can be driven have vehicle scanned for any trouble codes --be cautioned --stabili-trak is tied into abs and speed sensors and the transmission-engine -and can go into limp mode -this problem sometimes has been known to show up and clear itself ---check your hubs- abs wiring and sensors -speed sensors --check that debris didnt damage or disconnect any wires or connections also traverse would kick up stabilitrak problem with a fuel management problem
Electronic stability control Chevy Traverse Stabilitrak Traction Control problems

what is causing my airbag light, abs light and battery light to ...

https://answers.yahoo.com/question/index?qid...
Jul 12, 2014 - My battery light stays on sometimes it might blink on and off. But the problem is i can be driving my car and my airbag light and abs light will ...

Electrics HELP! Engine management light, Brake, Airbag, ABS, EPS ...

www.civinfo.com > ... > Bugs, faults and irritations
Feb 12, 2012 - 18 posts - ‎5 authors Airbag light. ABS ALSO - the speedometer, rev counter and engine temp ... 30 mins driving (apart from engine management light which stays on). ... I have ruled out problems with the alternator and the relays - they're all fine.

airbag abs srs light diagnose without a scanner air bag ...

? 4:14
www.youtube.com/watch?v=tIBjIr9a42w
Feb 6, 2010 - Uploaded by vehix411 airbag abs srs light diagnose without a scanner air bag ... Alsowhen I tried the scan plugging the paper ...

Why not use you warrantee at the dealer

We can not diagnose a vehicle without it
& you gave us no codes

The point here is you risking damage with a
skid,trac,abs etc issue if you keep driving it

All wheel drive I would never get on anything unless
your a vehicle tech & know how to use it & repair it
they do & will fail more then other combinations

Rust on the abs sensor or bad connection the trak light is tied into the check engine light but will not usually throw a code may get a code with a scanner that does abs brakes

For quirky things like that, I' look first at your ignition switch (common problem). Not the switch the key goes into, but it' located under the steering wheel column cover, on the bottom (black). Did your key get stuck in the ignition too at some point?

check the sensors and connections may have loosened or knocked one loose if they look ok than have truck scanned most auto stores such as auto zone/advanced auto scan for free the trouble code will narrow the problem

It sounds like you have a faulty ABCM or anti-lock braking control mechanism. 2003 was a common year for failure of this. Usually your car will drive just fine, however, your ABS and traction control might not work as well as there supposed too in a collision.

Have you checked your brake fluid? It may be low or an indication that the brake pads are worn, causing the light to stay on.