How do you replace an in cabin micro filter on a 2008 nissan rogue

Cabin Filter Replacement Nissan Rogue 2014 2017 2014 Nissan Rogue SL 2 5L...

It located in the passenger side of the car under the dash

If you mean rogue, there should be a cover for your in cabin filter right by the gas pedal to the right towards the fire wall. It should be fairly skinny in size and just unclog the cover and pull out existing filter. To replace, just reverse the step. Quick tip is to pinch filter in the middle like a bow tie to help fit back in easier. Hope this helps you out and GL

On the 2009 Rouge I have the blower motor resistor is located behind the cabin filter on the drivers side near the gas pedal. Followed the suggestion above and had to reinstall the glovebox as ipart was located on the opposite side. thx for that

it should be located under the hood somewhere on the firewall.If in doubt the parts store where you get the filter can look it up in the same book the look your filter up in

It is the battery. It is bad and shorting out. Check the manual for directions to trouble shoot until you replace it. There is a small button that you need to remove next to the shifter, place the key in the hole and hold for about 10 seconds. It is a shift release.

I had the same problem. Fixed!

Hello, I'm sending you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Thanks

Most likely there is a leaf in your fan that is throwing it off balance.. Im not to sure but you can try taking the cabin air filter out and reaching in where the filter was to see if you can feel the fan.. Other than that i think you would have to take the fan out through the bottom of your dash.

I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.