Will all parts interchange between a 1993 chevrolet K1500 and a 1995 1500 z71 pickup truck?

SOURCE: Chevrolet Silverardo C/K 4x4 Z71 offroad pickup 1500 1998

You can purchase a manual books from either Chilton or Haynes Repair Manuals. You can buy them from Autozone, O'Reily, or checker.

Harvey N Tawatao

• 3854 Answers
• Posted on Jun 20, 2009

SOURCE: Fuel Pump

The fuel pump is in the gas tank, the best way to do this is to get some friends and remove the bed from the frame. There is i believe 8 bolts that hold the bed to the frame, and don't forget to remove the hardware to the gas tank filler neck. Once the bed is off the frame, you can get to the fuel tank. Disconnect the wire harness and might as well replace the harness since there only $12.00 last i looked, disconnect the fuel line and return line. Remove the fuel pump retainer ring and lift up on the fuel pump sending unit. To install replace the rubber O ring and oil it before installing the new fuel pump sending unit. Install the fuel sending unit retaining ring, gas lines, new wire harness, and filler tube. Good lime also to check the hose to the EVAP since you can inspect them, look for any dry rot to the vacuum lines and replace if needed. Reinstall the bed and use lock tight to the bed bolts or replace them with stainless bolts. Good luck and hope this helps, oh and you might as well change the fuel filter while your have the bed off. The other way is to drop the gas tank which means draining the tank and raising the truck. 

SOURCE: need schematics

http://manualfox.com/schematic.htm

Ask them, they will get it for you.

Stan Cather

• 414 Answers
• Posted on Jul 12, 2009

SOURCE: Lost Reverse in my 97 Z71 chevy pickup truck and

trans needs to be rebuilt most likley.

SOURCE: what model 4L60E tranny's can I put in my 1998

the way i figured which 4l60e works with my truck was to get the service number off of the ecm. Then I took that ecm service number and searched for it on ebay. People selling that same ecm will usually list what other vehicles that ecm works on. Then I went to the u-pull&pay and got a tranny out of one of those vehicles. I do know that after 95 there is an extra pin in the main wiring harness that goes to the PWM. My 94 tranny didn't have that pin. Also try pulling the main wiring harness out of your tranny and with a mirror look down into the tranny and get the pin configuration. Make sure the one you get also has that same pin layout.