SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: replacing a starter in a PT. Cruiser 2001
Remove battery and battery support you'll be able to undo starter bolt's trough there and slip starter out.
Testimonial: "This didn't help, because you had to remove the engine structural collar under the starter to get at the starter bolt. It was more complicated."
SOURCE: '05 PT Cruiser O2 sensor problems.
I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.
SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...
GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP
SOURCE: how do I replace a 2005 pt cruiser camshaft sensor
Camshaft sensor sit in the end of the cylinder head, drives side, just unscrew both little bolt's from sensor, remove sensor, and install new cam sensor, no reprogramming needs to be done.
421 views
Usually answered in minutes!
×