SOURCE: 1998 Ford Windstar AC compressor
They get more than warm, but not excessively hot that you can't touch it. This can be caused by a faulty condenser fan motor, dirty condenser coil even low freon, which is my guess along with a dirty condenser. Check these two issues and if it's not the problem your compressor may be getting ready to die. because of internal issues with the motor windings. Make sure the fan is running to speed, clean the condenser and see if the larger copper pipe to the compressor is ice cold and sweaty, if not you may need freon
SOURCE: 1998 Ford Windstar Transmission to 2000 Ford Windstar
while it is possible to perform that swap, the newer 2000+ transmissions will have updated internals and such.
so will it work............. yes.
is it optimal.................no.
SOURCE: illustrated diagram on how to remove speed sensor for windstar 98
The Vehicle Speed Sensor is located on transaxle, at the rear of the engine. I would check the harness connector to be sure it is clean and connected tightly. Also check the wiring for cuts and chaffing. Since it is fairly inexpensive, only about $42.00 from Ford, you may want to consider replacing it, at least to eliminate it as a possibility. You may want to go to a muffler shop to have this done like speedy, I believe the flex pipe needs to be undone to get to the VVS. If there is an Auto Zone around your area, you could always ask them for the step by step instructions to replacing the VVS, and it's free of charge. Good luck and hope this helps.
SOURCE: vacuum line diagram for 1998 windstar
look on the engine compartment either on the finder or the hood
SOURCE: Atmospheric Pressure SensorI have a 2001 Mitsubishi Galant GDI. C
Its located in the air filter housing....The volume air flow sensor also incorporates the barometric pressure sensor and the air intake sensor....If you are replacing either of these sensors replace the volume airflow sensor.......
53 views
Usually answered in minutes!
×