Rear tail shaft sensor .drives side of trans .
That is in limp mode, so you can drive slow short distance for help
Get a scan done on it
Usually fluid level low & or solenoid failure.
Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try
SOURCE: goes to 4000 rpms to 5500 rpms before changing from 1st to 2nd g
Ford : back the truck up 10ft put truck in neutral and disengage four wheel low. (You can't drive in four wheel low cause its a pulling gear and you won't do over 3-5 mph.)
Nissan: start truck see if it idles normal. If so rev motor and check throttle for sticking and check EGR valve make sure its not stuck open or malfunctioning when you drive it..
SOURCE: won't come out of 4 low and won't change from 1st to 2nd gear
try checking your auto trani fluid... and with the 4 wheel drive try puting ti in nuteral and if the doesnt work try puting it in reverse and back up after taking it out of 4 wheel drive.
SOURCE: 96 chevy blazer 3rd gear and overdrive slipping
i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do
144 views
Usually answered in minutes!
that speed sensor controls shift from second gear to 3rd..been there done that ..
×