Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Sep 08, 2019

My indicators are not working & neither are the hazard. Dashboard indicator light not showing.

I have a peugeot 106 R reg. The signal relay ticks once, which I can feel with my fingers on top, but doesn't continue past the single tick. Can anyone help?

1 Answer

stephen peirce

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Peugeot Master 1,882 Answers
  • Posted on Sep 08, 2019
stephen peirce
Peugeot Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Dec 29, 2012
Answers
1882
Questions
0
Helped
669868
Points
5406

There's a dual flasher that the relay sends power to it for the signals and emergency signals the flasher gives the intermittent blinking to them and yours can either be a much larger sized relay looking one or a round 3 prong can this can either be in the fuse box or above it in the dash board

1 Related Answer

Anonymous

  • 1 Answer
  • Posted on May 30, 2009

SOURCE: turn indicator sound (ticking) continues after signal is cancelled. replaced flasher and sound continues.

Remove the signal lever (switch) clean the grease completely and lube again with di-electric grease.
This should solve your problem.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Renault Sandero Stepway hazard lights issue

I would think its a flasher relay or switch problem, do the indicators work when used via the stalk switch ? if they do then I'd start with the hazard switch
0helpful
1answer

Peugeot 407 HDI Indicator problem

you can solve your problem with the help of service and repair manual which you can get easily from the given link http://toolsnyou.com/
2helpful
1answer

Hazard stop flashing after 1 minute and stays on

Yes, I replaced the relay box and it worked.
0helpful
1answer

My left indicators have stopped working but when i press my hazards they all work fine and so does my right side too, it makes a sound but no lights show on the dash for the left signal, I have a renault...

Looks like ur INTERMITENT RELAY SWiTCH for signal light is not working. Yes, its giving light for the signal light in the exterior but in ur indicator it doesn't shows, the relay has 3 terminal, the center is for the power and the two are for the lights in the indicator! Replace the relay and it will light up!
Hope that helps u out!
0helpful
1answer

Indicator problems when it rains on a Peugeot 106

is ther water getting into your lamp units
2helpful
2answers

Blinkers not working on 99 saturn SL1 (hazards not working either). All Other electrical (radio, headlights,brake lights are working) appears ok,fuses are good. Whats the problem? Blinkers went out without...

Check/replace the flasher control unit.
This unit is usually located under the dashboard. (It's the unit that normally sounds the audible 'click- click ' when the indicators flash).
1helpful
2answers

I have a peugeot expert van 02 model 1.9 diesel fault is indicators stopped working and no hazard lights all lights flash when using central locking ive checked all fuses in interior and in engine...

check to see if you have power at the hazard light switch, it could just be unplugged, if u can get another good switch swap them over, i know its a power prob to that haz switch.
0helpful
1answer

Light indicator problems

I would say try and REPLACE the turn signal fuse/relay. It should be a square, black fuse/relay on your fuse panel. They run about $10.00.

c0b6c35.jpg
0helpful
1answer

Indicators on peugeot 406

U mean the turn signal switch, never heard it referred to that way, at least here in the US, anyway have u replaced the turn signal flasher?, that is the electrical device that actually makes the lights blink, it is separate from the 4 way flasher, U will most likely ask where it is, I have no answer for that, post that question on a new thread and maybe some other expert can answer it for u.
5helpful
2answers

Hazard Lights working. Indicators will not operate/flash

The Hazard and turn signals share the same relay module located in the dashboard behind the hazard switch. Remove the trim by prying from the sides (Either side of the Cup holder drawer and Card drawer). Pry the hazard switch assembly out from the dashboard. The relay is part of the hazard switch assembly.

Unclip the wiring terminal from the relay. replace with appropriate relay. Part costs under $50.00 delivered from Import Parts Specialists.
Not finding what you are looking for?

495 views

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...