Question about Holden Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: passenger electric window
I think that what has happened with your vehicle, is that the master (driver control) switch has become defective....If you have a friend who is good with electronics you may be able to ask for help in getting it fixed....otherwise a new unit is needed.
Posted on Aug 20, 2008
Without proper electrical diagnostic equipment and based on the very through description that you gave I would suggest getting a new switch. I say a new switch because on the drivers side the switch is one giant junction block. I have the same vehicle and had my door panel off for some locking issues.
I have attached a link to Ford Direct. The part that you are looking for is Window switch, explorer, 4 door, right
Posted on Jan 19, 2009
You'll need a torx bit for the bottom screws. The door handle comes apart (using a screw driver) to expose 2 phillips screws holding the door handle to the door, after you get those out, pop the rest of the push clips out by firmly pulling on the door panel near the bottom, There may also be another screw on the TOP Front (near the mirror) very small phillips. Once you have the door panel loose, lift UP on the door panel to remove. Once you get that panel off, you'll have to remove all the other screws to get the window regulator out (lots of 10mm bolts). Unclip / unconnect the connections etc..
Posted on Jul 11, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
Posted on Sep 23, 2009
Sounds like you have a problem with your window regulator. you need to unbolt the motor from the panel and take window off the regulator. I also have a 99 intrigue and my drivers side window did the same thing. The wire cords on the regulator where frayed and we replaced it. Found a new one of Autopartswarehouse.com for about $42 dollars with the motor.
Posted on Aug 22, 2010
Tips for a great answer:
Sep 25, 2018 | Holden Cars & Trucks
Sep 12, 2018 | Holden Cars & Trucks
May 17, 2018 | Holden Cars & Trucks
Dec 22, 2017 | Holden Cars & Trucks
Jul 06, 2017 | Holden Cars & Trucks
Jun 26, 2017 | Holden Cars & Trucks
Nov 23, 2015 | Holden Cars & Trucks
Jan 16, 2018 | Holden Cruze Cars & Trucks
Feb 04, 2012 | Cars & Trucks
43 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: