NO FOBS DETECTED
Refer to Keyless Entry System Description and Operation
Keyless Entry System Description and Operation - Passive
Passive keyless entry allows entry to a locked vehicle without pressing any buttons on the keyless entry transmitter. You must only have the transmitter with you. This passive system is also part of the vehicle starting system. It allows you to start and run the vehicle having only the transmitter as your key. The passive entry and starting system use low frequency antennas in 4 different areas on the vehicle to determine the location of the transmitter. When passively opening a locked door or the rear compartment lid, you must have a programmed transmitter with you in your pocket, purse, or briefcase. As a customer opens the door handle or presses rear compartment touch pad, the low frequency antenna sends out a challenge to the keyless entry transmitter. The transmitter must be in a one meter range of the door or rear compartment lid in order to receive the challenge. If the challenge is met, the transmitter will respond, allowing the door to be unlocked and opened. Passive entry allows you to operate the following features:
• Passive door unlock/unlatch
• Passive rear compartment lid release
• Illuminated entry lamps
• Vehicle starting
The keyless entry system has the following components:
• Keyless entry transmitters
• LH and RH door antennas (part of the door handle assembly)
• Rear compartment antenna
• Console passive antenna
• Console active antenna
• Instrument Panel Module (IPM)
• Rear Integration Module (RIM)
• Remote Control Door Lock Receiver (RCDLR)
• External RF Antenna (includes coax from RCDLR to back glass)
Remote Control Door Lock Receiver (RCDLR)
The RCDLR is a multi-function module which controls all the vehicles antennas for passive keyless entry functions. The RCDLR also acts as the receiver for active keyless entry and tire pressure monitoring (TPM) functions, as well as controlling all immobilizer functions.
The RCDLR's RF antenna is located in the back glass, and there is a coax cable connecting the glass antenna to the module located in the trunk.
Your best bet , take it to a qualified repair shop that has the factory Tech 2 scan tool or someother professional type scanner that can read • Rear Integration Module (RIM) DTC'S - diagnostic trouble codes .
SOURCE: NO FOB DETECTED
Slight glitch from what I've found. Has happened to me at the gas pump. One other time while talking outside my car with out opening the doors. If No FOB detected then step out of the car lock and unlock, get back in and try. If still dosen't detect then you need to walk twenty feet away with your key and it should reset.
SOURCE: cadillac sts dead battery cant open car with
Don't you still have a door key?Otherwise jack up the car and remove the engine under body cover.Between the radiator support and the engine are some hard lines.Remove the two brackets holding them,this will allow you room to get to the starter.Hook the red end of a jumper cable to the red battery cable that's connected to the starter.Black to a suitable ground and charge the battery.A battery charger is easier to use,use that if you have one.If jumping off a car make sure the cables are hooked to the dead car first and grounded to the engine not the battery of the car doing the charging.Sure hope this helps!
SOURCE: my 2006 cadillac sts key fob all of a sudden is
Check the fob battery you might need to replace it, The battery only has about a 3 year life
SOURCE: 2003 Lincoln Town Car 1. Used
Try resetting these features, Deactivating/activating the horn chirp feature The horn chirp feature can be turned on/off through the following procedure: Complete steps 1-7 within 30 seconds or you must repeat the procedure. Wait 30 seconds before repeating the procedure. 1. Turn the ignition to the ON position. 2. Press the power door unlock control on the door panel 3 times. 3. Cycle the ignition from the ON to the OFF position. 4. Press the power door unlock control 3 times. 5. Turn the ignition to the ON position. The doors will lock and unlock. 6. Press the unlock control twice within 5 seconds. The horn will chirp twice to indicate a successful activation/deactivation of the horn chirp feature. To deactivate/reactivate the autolock feature using the power door unlock control You must complete steps 1-7 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds. 1. Turn the ignition key to RUN. 2. Press the power door unlock control three times. 3. Turn the ignition key from RUN to OFF. 4. Press the power door unlock control three times. 5. Turn the ignition back to RUN. The horn will chirp. 6. Press the unlock control. The horn will chirp once to indicate the enabling/disabling of the autolock feature. 7. Turn the ignition to OFF. The horn will chirp once to confirm the procedure is complete. Pressing the power door unlock control again will toggle the Autolock/Relock states.
7. Turn the ignition to the OFF position.
Turn ignition to OFF to exit programming.
SOURCE: my 2006 cadillac sts key
My cadilliac sts 2005 key fob started no working. when I try to start it the car tells me that the key fob is not detected. I just changed the battery and it is still doing it. What else could be wrong with it:
2,758 views
Usually answered in minutes!
×