I went to roll the window down and it got stuck just before disappearing into the door panel. upon trying to roll it back up or down it wouldn't move. Now the window is completely behind the door panel and won't roll up.
You have to remove the door panel to get to the window crank assembly. The window has fallen off the pin the roller is on or a carrier bolt has come loose and let the window drop. You can hurt anything by removing the window crank and door handle then the panel to access the window crank assembly to see what went wrong.
SOURCE: door window on 2000 jaguar s type
take off inner door panel, lower track and put the window back in. If parts on track are broken buy new ones. Use urathain to reinstall window.
SOURCE: passenger side power window wont roll up
The problem may be in the wiring which if you pull up the carpet on the front passenger side by
removing the door floor trim and lifting the carpet you will see the
wiring underneath. Probably laying in water or has been. Look for splices in the
wiring which will have corroded. Repair the wiring then check the fuse.
Another problem may be in the motor found inside the door.
The brushes may have worn out. If so you need to replace the motor.
Ususally the drivers side will fail first since it is the most used.
SOURCE: Remove inside panel pass.side door of 2001 Dodge gr.caravan sport
1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery
Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.
SOURCE: Malfuntioning driver's side power window upon opening door lever.
get it to the dealer asap.
you definitely need to take apart the door. There's something not right inside.
SOURCE: Driver Side window will not come back up
be careful with jeeps they have a body control module that controls the windows , locks ect they go out often a dealer with scanner can check. also you have the window switch on the drivers door , rarely is it the regulator on a jeep
72 views
Usually answered in minutes!
×