Question about Hyundai Cars & Trucks

Open Question

Hyundai bakkie h100 tachometer not working but fuel gauge and speedometer are fine, what could be a possible cause?

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 27 Answers

SOURCE: Speedometer/ Fuel Gauge & Tachometer not working

check for loose connection at the instrument cluster.

Posted on Jun 29, 2008

Ad

Anonymous

  • 366 Answers

SOURCE: my gas, tachometer and speedometer are not working

check for blown fuse for gauges,light is a pro blem code,thatll have to be scanned to point at problem area.

Posted on Mar 08, 2009

Anonymous

  • 1 Answer

SOURCE: No speedometer, gas gauge, temperature gauge, and

check your fues box were it say gagues

Posted on Jul 01, 2009

tberan1

  • 523 Answers

SOURCE: 1998 Plymouth Grand Voyager instrument cluster problem

There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
As I fore mentioned I had the exact same issue as you are describing, our is a 99. The most tricky part is the dash, take your time with it.
I hope this may have assited you,
Tom

Posted on Oct 18, 2009

Anonymous

  • 1 Answer

SOURCE: speedometer, gas gauge, odometer, rpm gauge not working

My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Posted on Oct 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

H100 HYUNDAI MANUAL BAKKIE GEARBOX HOW DO I FILL IT


I had got its manual from online store www.reliable-store.com Here's the site link I am sure they will help you

Mar 03, 2018 | Hyundai Cars & Trucks

1 Answer

Does anyone know where i can get a crank shaft for a hyundai h100 2.6 the bakkie with the round head lights. Annelize


wreckers , spare parts at service dealer, engine reconditioner engineering shops
get yours ground

Apr 28, 2016 | Hyundai Cars & Trucks

2 Answers

My RPM meter is not working...it's always on 0.


I used to have a 1999 Mitsubishi Eclipse with the same symptoms; my mechanic replaced the speed sensor ($65) and the problem went away. Take the car to auto zone and ask them to plug the computer, they normally do it free of charge. If it is the sensor, you may have to buy at the dealer.

Oct 05, 2012 | 2000 Hyundai Sonata

2 Answers

My fuel gauge tach gauge speedometer heater temp gauge and driver power seat quit working


check the fuses. they are under the back seat just pull up on the lower part of the back seat and it will come out. fuse box is on the drivers side. check to see if water is getting in that could be the cause.

Feb 10, 2012 | 1996 Oldsmobile Aurora

1 Answer

Speedometer on my 2004 Tiburon works thens cuts down to zero. Gas gauge is doing the same thing. Just put gas in drop down to empty yet still has gas in it.


Clean the connectors on the back of the BCM and on the back of the gauge cluster.

If that doesn't work, then it could be:
- Fuel Sender & Vehicle Speed Sensor (should cause your "Check Engine" light to come on)
- Gauge Cluster
- BCM

You'll have to diagnose each of these possibilities.

Jan 16, 2010 | 2004 Hyundai Tiburon

1 Answer

Speedometer and tachometer


Both are in need of repair, nothing else will cause this kind of problem except the inner electronics of both instruments, they can be repaired by any authorized Hyundai electronics repair station, but it won't e cheap.

Nov 18, 2008 | 2002 Hyundai Santa Fe

1 Answer

Speedometer/ Fuel Gauge & Tachometer not working


check for loose connection at the instrument cluster.

Jun 28, 2008 | 2001 Volkswagen Beetle

2 Answers

Thermostat in a 1997 hyundai elantra


See exploded view
0d68e80.gif

REMOVAL
1. Drain the coolant down to thermostat level or below. 2. Remove the coolant outlet fitting and gasket. 3. Remove the thermostat

Jun 22, 2008 | 1997 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...