SOURCE: hyundai getz
if the speedo still works then it will need a spedo unit if the speedo doesn't work it is either the cable or the gear in the trans to check the cable unthread from trans and attach a drill to the cable innereds spin the drill if the speedo does not move replace the speedo cable
SOURCE: crank shaft position sensor located hyundai sonta 2004 v6
On a 2.7L it is located above and to the right of the starter. You will have remove the starter heat shield to gain access to it.
SOURCE: 1999 hyundai sonata misfires after replacing crank
if you changed the timing belt and balancer belt. you may be 1 tooth off. will miss like a champ if the belt was changed
SOURCE: I have a 2000 hyundai Sonata, 6 cylinder eng. My
The sensor is located on the left hand rear side of the block (near the bell housing). It is held in place by a 10mm bolt. It's to the right of the exhaust manifold (LH - radiator side) on the V6. Once you purchase the new sensor you'll be able to identify it on the engine. The connector to this sensor is located in the illustration.
A word to the wise... replace the O2 snsr as well.
SOURCE: crank shaft position sensor 2007 dodge caliber
Regards,
Tony
1,065 views
Usually answered in minutes!
×