Question about Suzuki Cars & Trucks

Open Question

Replacing a vacuum system with a electric wiper on a 1988 Suzuki samurai

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
lesabre1972

mike watson

  • 474 Answers

SOURCE: 1988 suzuki samurai WONT MOVE

First thing just try to push or pull the 4x4 lever if you get it to move and it feels like it went into some gear try to drive the truck.If this works look on the shifter for the 4x4 and put it in 2 wheel drive (H2 is two wheel drive,H4 is 4x4 high,and L4 is 4x4 low range).Make sure you have the clutch depresed when you try to move the 4x4 lever.If you try this stuff with no fix try and look for clutch adjustment on the transmision you may need to adjust it or your clutch is bad.

Posted on Aug 30, 2008

Ad

glenn chambers

  • 84 Answers

SOURCE: LEAKING OIL FROM T-CASE SHAFT TO TRANSMISSION

Have you tried the dealer, they should have this seal, if not let us know the measurements and we can help

Posted on Dec 23, 2008

Corey Daniels

  • 14 Answers

SOURCE: 1987 Suzuki Samurai alternator wiring. No original wire harness

yes the b goes to the battery.

http://bbs.zuwharrie.com

heres the site for you.. we have all the answers.

http://www.acksfaq.com/diagram_color_86-88_sam.htm

i drew this up a while back. it could help you out alot.

Posted on Apr 22, 2009

mecanica03

ROBERT GARCIA

  • 918 Answers

SOURCE: 1988 Samurai clicks when i try to start

this is an starter soleniod symptom

Posted on Jun 09, 2009

J F

  • 154 Answers

SOURCE: I have a 1988 suzuki

The transmission doesn't have a dipstick but it does have a fill level plug located at the rear of the extension housing, just to the passengers side. It is a round plug with a 3/8 square hole in it.
Fill trans till oil overflows out of this hole.
Use VMX80 or similar.

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a starter for a 1988 Suzuki Samurai


Disconnect negative terminal of battery.
Remove positive lead from starter solenoid.
Remove the solenoid wire (brown).
Remove two bolts holding starter to bellhousing.
Lift starter out.

Apr 16, 2012 | Suzuki Samurai Cars & Trucks

1 Answer

I have a 1987 samurai and replacing the head but I'm not sure if they are yield type head bolts! Can anyone help with this answer?


By "yield" type, I guess you are talking about the single purpose bolts. Samurai bolts are not the tapered type. The manual says nothing and I have used them over often with good reults

Feb 07, 2011 | 1988 Suzuki Samurai

1 Answer

88 suzuki sammy carb problem secondary dos not open up when it should


At the front of the carb is a big diaphragm connected to the front of the secondary throttle shaft by a link. Is this still connected ? Are the vacuum hoses connected to the diaphragm correctly? Next you will need to apply vacuum to the diaphragm to see if it holds vacuum. They often fail, which hinders the secondaries from opening

Dec 15, 2010 | 1988 Suzuki Samurai

1 Answer

When im driving my front end gets to shaking so bad i have to pull off the road, it use to quit when i mash the brake but not any more. Its a suzuki samurai 4-wheel drive


The ball joints need replacing and maybe the tierod ends too. That violent shaking can cause part failure which could cause you wreck the vehicle. Don't drive it usless it is inspected and repaired.

Mar 19, 2010 | 1988 Suzuki Samurai

1 Answer

1988 Samurai clicks when i try to start


this is an starter soleniod symptom

Jun 09, 2009 | 1988 Suzuki Samurai

1 Answer

Rear wheel bearings for my 1988 Suzuki Samurai


They are pressed in, not an easy job.

Feb 11, 2009 | 1988 Suzuki Samurai

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...