SOURCE: abs light, engine light
I have the same car, same problem and I've been doing some research. It seems to be that the most common problem is a faulty ABS sensor that causes the car to go into "Limp Home Mode". Limp Home Mode is automatically initialized when the car senses that it has some sort of electrical or mechanical issue. This is most likely what your experiencing, because I, and many other X-type owners are as well. Good Luck.
SOURCE: abs light/traction control light
You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.
SOURCE: ABS light comes on, traction light, and airbag
There should be a fuse between your battery and alt. If the fuse is blown, the current isnt getting back to the batt.
Something like this also happened to my brother in his Jetta, Im not saying its the same thing but his timing belt gave out.
SOURCE: My clutch won't go down and won't go into any
ABS light coming on,For this get the Engine computer scanned.It can be error codes stored in computer.------------
For more details regarding this click the link below:-----
The ABS and Traction
Control Lights stays ON dash of car?
http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
---------------
And now for clutch not going in gears it can be faulty clutch issue or problem with clutch cable.This has to be inspected.For more detailed instructions regarding Peugeot clutch problem,click the link below:-----
Peugeot 307: Clutch will no go in gears?
http://whoisbyme.blogspot.in/2012/05/peugeot-307-clutch-will-no-go-in-gears.html
---------
This will help.
Thanks.
Whenever
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
problem(s)
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
70 views
Usually answered in minutes!
×